Hitachi G200 Quick Start
Virtual storage platform
Hide thumbs
Also See for G200:
- Service manual (418 pages) ,
- User manual (252 pages) ,
- Hardware reference manual (148 pages)
Advertisement
Quick Links
1
Prepare for
Installation
2
Connect the
Hardware
1
1
Prepare for Installation
1. Unpack package contents.
CAUTION
LIFTING HAZARD
101.4 lbs.
Lift with 3 people.
(46 kg )
Hitachi Virtual Storage Platform
1
G200
Prepare for
Quick
Quick
Installation
2
3
Power Up
Start
the System
Connect the
Hardware
5
4
Run the Initial
Start
Setup Wizard
7
Complete System
Run the
Setup
Initial Startup
6
Wizard
START
START
Enable Hi-Track
Remote Monitoring System
Power, Fibre Channel,
iSCSI, and SAS
Cables (optional)
3
Power Up
the System
5
4
Run the
6
Initial Startup
Wizard
Enable Hi-Track
Remote Monitoring
System
Accessory
Box
Bezel
Controller
Software
Applications
Disk Drives
Power
Distribution
Units
Hitachi Virtual Storage Platform
Run the Initial
Setup Wizard
7
Complete System
Setup
8
Go to Support Connect at
https://support.hds.com
and subscribe to receive
important technical bulletins.
2. Provide these
items.
Management
Console PC
(with NIC)
Additional
Wrist
Cables
Strap
User-Supplied
Rack (if not
ordered from
Hitachi)
Uninterruptible
Power Supply (UPS)
Rack
(optional)
G200
Quick
Start
START
START
3. Install devices into
the rack.
SVP
Switch
Drive Trays
(units 2-4)
Controllers
(unit 1)
Do not turn on units until
instructed to do so.
HDS or User-Supplied Rack
Install the service processor (SVP) at the
top of the rack, and the controllers and
drive trays below it. Labels on the top of
the controller and drive trays identify the
units and their installation order. Install
the unit with the lowest number (for
example unit #1) at the bottom, and then
install the remaining trays (for example
unit 2, unit 3, and so on) in sequential
order above it.
NOTE
Advertisement
Related Manuals for Hitachi G200
Summary of Contents for Hitachi G200
- Page 1 Hitachi Virtual Storage Platform G200 Prepare for Installation Quick Power Up the System Start Connect the Run the Initial Hardware Setup Wizard Complete System Run the Setup Initial Startup Wizard Enable Hi-Track START START Remote Monitoring System Go to Support Connect at https://support.hds.com...
- Page 2 Connect the Hardware 1. Connect expansion ports to drive trays. Ports are color-coded for reference. Cables should lock into place. Verify they do not pull out without using the tab. SAS cable POWER LOCATE ALARM POWER LOCATE ALARM CONSOLE CONSOLE Drive Tray 2.
-
Page 3: Remote Desktop Connection
4. Complete the Initial Startup elds. Run the Initial Setup Wizard If you will use advanced Hitachi software applications, refer to the control memory section in the NOTE Hardware Installation and Reference Guide to see whether additional control memory must be installed. - Page 4 Enable Hi-Track Remote Monitoring System Hi-Track provides the remote monitoring and support functionality for Hitachi products. Hitachi recommends you install and con gure Hi-Track to monitor the storage system at the customer site. For more information, access the Hi-Track documentation at http://hitrack.hds.com/.