Silvercrest SKRD 30 A1 Operating Instructions Manual
Under-cabinet radio
Hide thumbs
Also See for SKRD 30 A1:
- Operating instructions manual (54 pages) ,
- Operating instructions manual (158 pages) ,
- Operating instructions manual (132 pages)
Related Manuals for Silvercrest SKRD 30 A1
Summary of Contents for Silvercrest SKRD 30 A1
- Page 1 Under-Cabinet Radio SKRD 30 A1 Under-Cabinet Radio Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www.kompernass.com ID-Nr.: SKRD 30 A1-09/10-V3...
- Page 2 SKRD 30 A1 5 6 7 8 9 0 q w e...
-
Page 3: Table Of Contents
Starting the kitchen timer ..15 Pausing the kitchen timer..15 SKRD 30 A1 Programming the kitchen timer ..16 Accessing the kitchen timer ..16 Programming alarm wake times . -
Page 4: Introduction
Information for these operating instructions These operating instructions are a component of the Under-Cabinet Radio SKRD 30 A1 (henceforth designated as the device) and they provide you with important information about the intended use, safety, installation and connection as well as operation of the device. -
Page 5: Warning Notices
If the situation is not avoided it can lead to property damage. ► The directives in this warning are there to avoid property damage. NOTICE ► A notice signifi es additional information that assists in the handling of the device. SKRD 30 A1... -
Page 6: Safety
Wear protective gloves. ► Store batteries in a place inaccessible to children. If swallowed seek immediate medical attention. ► If you do not intend to use the device for an extended period of time, remove the batteries. Introduction SKRD 30 A1... -
Page 7: Basic Safety Instructions
Avoid direct sunlight. ■ Always pull on the power plug when disconnecting from the wall socket, never pull on the connection cable. ■ If malfunctions occur or thunder storms threaten pull the power plug from the wall socket. SKRD 30 A1... -
Page 8: Operating Components
Tune–: Decrease the reception frequency Tune+: Increase the reception frequency VOLUME/Snooze/Timer: Volume control/Alarm switch off /Timer setting Wire antenna for VHF reception Mains connection cable Recesses for stand Speakers Battery compartment Unlocking buttons for the mounting plate Operating components SKRD 30 A1... -
Page 9: Setting Up And Connecting
To avoid risks to persons and property, observe the requirements for the set-up location and the electrical connections. Package contents and transport inspection The device is delivered with the following components as standard: ▯ Under-Cabinet Radio SKRD 30 A1 ▯ Mounting plate/Stand ▯ 4 Securing screws ▯... -
Page 10: Disposal Of The Packaging
■ Make sure that the connection cable is not tightly stretched or bent. ■ Do not allow the connection cord to hang over edges (Trip wire eff ect). Setting up and connecting SKRD 30 A1... -
Page 11: Inserting The Battery
♦ Check to make sure that the device is secure. SKRD 30 A1 you can mount the device under, for exam- on the rear panel of the device downwards under the set-up location. Thereby the front should be approx. -
Page 12: Disassembly
. The mounting plate can now be used as a stand. power plug into a socket. The time of (0:00 o'clock). completely for VHF reception. and remove the mounting . For assembly of the stand backwards and remove into the rear recesses into the front recesses SKRD 30 A1... -
Page 13: Handling And Operation
The setting menu ends automatically if you do not actuate any buttons for approx. 15 seconds. The executed setting is saved. SKRD 30 A1 button you switch between the operational modes clock/ does not disconnect the device completely from the must be pulled from the mains socket. -
Page 14: Setting The Time
Tune– the current time of day. With button again to save the current setting and button twice. The date indicator begins to and Tune– the current date. With each button again to save the current setting and SKRD 30 A1... -
Page 15: Adjusting The Display Brightness
♦ Press the Bass/AMS/Mode move to the next menu item. SKRD 30 A1 button three times. The current setting for the , the display brightness to H if you want the , the display brightness to L if you want the button again to save the current setting and button four times. -
Page 16: Setting The Time Of Day Format
12 if you want a button again to save the current setting and button. The display shows 00 : 00. In the right knob to set the time range for the kitchen timer. SKRD 30 A1... -
Page 17: Starting The Kitchen Timer
♦ To switch off the kitchen timer before the set time has expired press and hold down the Snooze/Timer SKRD 30 A1 again. The displayed again to allow to switch off the kitchen timer alarm signal. again to allow the remaining time button for at least 2 seconds. -
Page 18: Programming The Kitchen Timer
Under the and Preset– a memory slot between again to programme the set time on the to activate the kitchen timer. and Preset– the desired timer between again to start the kitchen timer. SKRD 30 A1... -
Page 19: Programming Alarm Wake Times
♦ To select "Alarm tone" for the respective alarm press the Alarm1 button or the Alarm2 button the symbol SKRD 30 A1 or the Alarm2 button and Tune– the desired wake time. With to switch between the weekday combinations Mo-Fr,... -
Page 20: Waken With Radio
9 minutes. or the Alarm2 button button. button. or the , the or the Alarm2 to end the current SKRD 30 A1... -
Page 21: Radio Operation
The device searches for the nearest station with suffi cient reception quality. ♦ Repeat this process until you have found the station you are looking for. SKRD 30 A1 knob set the desired volume. Turning in a clockwise and Tune–... -
Page 22: Saving Stations Manually
If less than 30 stations are found the last memory slots remain unchanged. Handling and operation once. The symbol MEM begins to blink in and Preset– the desired memory slot again. The reception frequency of the tuned and Preset– the desired memory slot for at least two SKRD 30 A1... -
Page 23: Additional Functions
Press briefl y the button Bass/AMS/Mode on or off . With the bass accentuation switched on the symbol BASS appears in the display. SKRD 30 A1 . The current remaining time repeatedly to set the desired time. Holding down appears in the display. -
Page 24: Cleaning
Repairs to electronic devices may only be carried out by specialists who have been trained by the manufacturer. Considerable danger to the con- sumer and damage to the device can occur as a result of incorrect repairs. Cleaning/Troubleshooting SKRD 30 A1... -
Page 25: Malfunction Causes And Remedies
Reception is too weak. NOTICE ► If you cannot solve the problem with the aforementioned methods, please contact Customer Service. SKRD 30 A1 Solution Insert the plug into the mains power socket. Check the circuit fuse. Increase the volume with the VOLUME knob. -
Page 26: Storage/Disposal
This obligation is intended to ensure that batteries are disposed of in an environmentally friendly manner. Hand batteries in only when they are fully discharged. Storage/Disposal SKRD 30 A1... -
Page 27: Appendix
Radio frequency range (VHF) Operating temperature Humidity (no condensation) Measurements (H x W x D): (without stand) Weight Protection class SKRD 30 A1 220-240 V / 50 Hz 1 x 3 V Type CR2032 (supplied) approx. 5 approx. 1.8 approx. 1W (with 10 % harmonic distortion) 87.5 - 108 MHz... -
Page 28: Warranty
Tel.: 0871 5000 700 E-Mail: support.uk@kompernass.com Kompernass Service Ireland Tel: 1850 930 412 Standard call rates apply. Mobile operators may vary. E-Mail: support.ie@kompernass.com Importer KOMPERNASS GMBH BURGSTRASSE 21 44867 BOCHUM, GERMANY www.kompernass.com (£ 0.10 / minute) (0,082 EUR/Min.) Appendix SKRD 30 A1...