hit counter script

Troubleshooting - Electrolux TW SL4 E User Manual

Hide thumbs Also See for TW SL4 E:
Table of Contents

Advertisement

Available languages

Available languages

Do not use sharp objects to clean the
heat exchanger compartment.
Do not operate the tumble dryer with-
out the filters.
CLEANING THE DRUM
Warning! Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent to
clean the inner surface of the drum and
drum ribs. Dry the cleaned surfaces with a
soft cloth.

TROUBLESHOOTING

TROUBLESHOOTING
1)
Problem
The tumble dryer is not connected to
mains supply.
The loading door is opened.
The tumble
dryer does
The Auto/Off button was not pushed.
not operate.
The Start/Pause button was not push-
ed.
The appliance is in the standby mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in minimum
mode.
Unsatisfactory
The condenser is clogged.
drying results.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the drum.
Too high water hardness.
The filter not locked in the position.
The door
does not
The laundry is locked between the door
close.
and the seal.
You try to change the programme or the
function after the start of the cycle.
Err (Error) on
The function you try to activate is not
the display.
applicable with the selected pro-
gramme.
No drum light
Defective drum light.
Possible cause
Caution! Do not use abrasive materials
or steel wool to clean the drum.
CLEANING THE CONTROL PANEL AND
HOUSING
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
Caution! Do not use furniture cleaning
agents or cleaning agents which can
cause corrosion to clean the appliance.
Connect in at mains socket. Check fuse
in fuse box (domestic installation).
Close the loading door.
Push the Auto/Off button.
Push the Start/Pause button.
Push the Auto/Off button.
Do the selection of the applicable pro-
2)
gramme.
Clean the filter.
Change the Dry Plus function to the
moderate or maximum mode.
Clean the condenser.
Obey the maximum load volume.
Clean the airflow grill in the bottom of
the appliance.
Clean the inner surface of the drum.
Set applicable water hardness
Put the filter in the correct position.
Put the load correctly in the drum.
Turn the tumble dryer off and on. Make
the new selection.
Turn the tumble dryer off and on. Make
the new selection.
Contact the service centre to replace
the drum light.
electrolux 39
Remedy
3)
3)
4)
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tw sl eevTw gl5 e

Table of Contents