Table of Contents
Advertisement
Class I, Division 2, Group A, B, C, D Tx;
Class I, Zone 2, Group IIC Tx
12.1.1.7
Tick mark for Australia and New Zealand
The components described satisfy the requirements of the following standard:
EN 61000-6-4: 2007 + A1: 2011
12.1.1.8
Safety regulations and special requirements
The components described satisfy the requirements and criteria of the following standard:
IEC 61010-2-201:2017 (Second Edition) / EN 61010-2-201:2017
(Note: These standards were supplemented by IEC 61010-1:2010 (Third Edition) / EN
61010-1:2010)
12.1.1.9
Standards for communication connections
The components described satisfy the requirements of the following standards:
● IEC 61158
● IEC 61784
– The following applies for communication with the automation system over PROFINET:
– The following applies for communication with field devices over PROFIBUS PA:
12.1.2
Electromagnetic Compatibility
Introduction
This chapter provides you with information on the immunity to interference of the described
components as well as on radio interference suppression.
The described components meet, among others, the requirements of the EMC legislation of
the European single market.
Definition: EMC
Electromagnetic compatibility (EMC) is the capacity of an electrical installation to function
satisfactorily in its electromagnetic environment without affecting that environment.
EMC in accordance with NE21
The S7 CPU 410-5H automation system with connected CFU meets the EMC requirements
according to NAMUR Guideline NE21.
SIMATIC CFU
Commissioning Manual, 07/2018, A5E39252870-AC
Compliance to IEC 61784 Ed.2:2007 CPF 3/5
Compliance to IEC 61784 Ed.2:2007 CPF 3/2
Technical specifications
12.1 General technical specifications
131
- Quick Links:
- Pa Profiles for Field Devices on...
Hide quick links:
Advertisement
Table of Contents
