Table of Contents
Advertisement
Attaching a front bezel
Complete the following steps to attach the front bezel to the array chassis.
CAUTION! Attach the front bezel carefully. Otherwise, you may
pinch your fingers between the bezel and the chassis as it snaps
closed.
NOTE: When installing or removing the front bezel, be careful not to
operate the main switch with the hook or the ON/OFF button of the front
bezel. You must unlock the front bezel before you can install it.
1. Insert the key into the keyhole on the front bezel and unlock the lock.
2. Grasp the front bezel on both sides and above the center of the unit.
3. Engage the two hooks at the bottom of the front bezel into the slots on
the array chassis, as shown in
4. Push the front bezel toward the chassis to engage it into the ball catches.
5. Remove the key from the front bezel and store it in a safe place.
Attaching a front bezel to the modular 2U SAS expansion unit
Complete the following steps to attach the front bezel to the modular 2U
SAS expansion unit.
CAUTION! Attach the front bezel carefully. Otherwise, you may
pinch your fingers between the bezel and the chassis as it snaps
closed.
1. Insert the key into the keyhole on the front bezel and unlock the lock.
2. Insert the claw on the front side of the subsystem main body into the
claw hole in the front bezel.
3. Fix the front bezel by pressing the right side of the front bezel to engage
the hook of the front bezel with the ball catch.
4. Remove the key from the front bezel and store it in a safe place.
Replacing parts
Hitachi AMS 2000 Family Storage System Service Guide
Figure
4-1.
4–7
- Quick Links:
- Replacing a Control Unit
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
