Never Use A Stabilizer Or Printable Discs; Beware Of Condensation; Connections; Control Connections - Tascam CD-RW901 Owner's Manual
Cd rewritable recorder
Hide thumbs
Also See for CD-RW901:
- Owner's manual (40 pages) ,
- Technical documentation (3 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Never use a stabilizer or printable discs
Using commercially available CD stabilizers or print-
able recordable discs with this player will damage the
mechanism and cause it to malfunction.
Beware of condensation
If the unit (or a compact disc) is moved from a cold to a
warm place, or used after a sudden temperature change,
there is a danger of condensation; vapor in the air could
condense on the internal mechanism, making correct
Connections
The following should be noted when you connect the
unit to other equipment.
It is possible to connect the unit's
IN
,
DIGITAL OPTICAL IN
,
and balanced or unbalanced
other equipment at the same time. However, the unit
can receive signals from only one digital input at a time.
Currently selected input jack is shown on the display.
Control connections
The pinouts of the
CONTROL I/O
the rear panel (see "Rear panel" on page 11) are:
Pin
Function
1
STOP TALLY OUT
2
REC TALLY OUT
3
SKIP (forward) IN
4
SKIP (back) IN
5
EOM TALLY OUT
6
REC IN
7
CALL IN
8
GND
9
PLAY TALLY OUT
10
READY TALLY OUT
11
FADER, START/STOP
12
STOP IN
13
PLAY IN
14
READY IN
a
15
+5V
a. The maximum current supplied from this terminal is 50 mA.
DIGITAL COAXIAL
DIGITAL IN (AES/EBU)
,
ANALOG INs (L, R)
to
(parallel) terminal on
1 − Introduction
NOTE
Never use a disc that has had a stabilizer mounted
to it. The residual adhesive may cause the disc to
stick to the turntable of the CD-RW901. If it sticks
to the turntable, you will need a technician to get it
out.
operation impossible. To prevent this, or if this occurs,
let the player sit for one or two hours at the new room
temperature before using.
Audio signals output from the unit are output from the
balanced or unbalanced
ANALOG OUT
from the
DIGITAL COAXIAL OUT
and
OUT
DIGITAL OUT (AES/EBU)
neously (but not from the digital outputs in stop mode).
Currently selected input jack is shown on the display.
Tall signals are open collector, with a maximum current
of 50 mA. Input signals are active when low (groun) for
≥ 30 ms.
A fader start/stop control should be wired according to
the following schematic:
STOP
Pin 8 GND
START
jacks, as well as
,
DIGITAL OPTICAL
connector simulta -
Pin 11
FADER START/STOP
9
TASCAM CD-RW901
Advertisement
Table of Contents
