Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
HS-HST-HSB WALL HOODS
APPROVED FOR
RESIDENTIAL APPLIANCES
FOR RESIDENTIAL USE ONLY
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
INSTALLATION MUST COMPLY WITH ALL LOCAL CODES.
IMPORTANT:
INSTALLER:
OWNER:
Safety Warning: Turn off power circuit at service panel and lock out
panel, before wiring this appliance.
Requirement: 120 V AC, 60 Hz. 15 or 20 A Branch Circuit
READ AND SAVE THESE INSTRUCTIONS
Advertisement
Related Manuals for Thermador HS Series
Summary of Contents for Thermador HS Series
- Page 1 INSTALLATION INSTRUCTIONS HS-HST-HSB WALL HOODS APPROVED FOR RESIDENTIAL APPLIANCES FOR RESIDENTIAL USE ONLY PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: INSTALLER: OWNER: Safety Warning: Turn off power circuit at service panel and lock out panel, before wiring this appliance.
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS CAUTION: FOR GENERAL VENTI- LATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VA- PORS. WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: CAUTION: To reduce risk of fire and to properly exhaust air, be sure to duct air outside - do not vent exhaust air into spaces... - Page 3 IMPORTANT SAFETY INSTRUCTIONS WARNING - TO REDUCE THE RISK WARNING - TO REDUCE THE OF A RANGE TOP GREASE FIRE. RISK OF INJURY TO PERSONS, IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING ONLY Page 3...
- Page 4 LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES ATTENTION: SEULEMENT POUR L’UTILISATION D’AÉRATION. NE PAS L’UTILISER POUR ÉPUISER LA VAPEUR OU LES MATIÈRES EXPLOSIVES OU DANGEREUSES. AVERTISSEMENT POUR RÉDUIRE RISQUE D’INCENDIE, CHOC ÉLECTRIQUE, BLESSURE AUX PERSONNES, OB- SERVER LE SUIVANT: ATTENTION: Pour réduire le risque d’incendie, utiliser seulement le travail du conduit métallique.
- Page 5 LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES AVERTISSEMENT POUR AVERTISSEMENT: POUR RÉDUIRE LE RISQUE D’UN FEU RÉDUIRE RISQUE DE GRAISSE DU SOMMET DE LA BLESSURE AUX PERSONNES CUISINIÈRE: DANS L’ÉVÉNEMENT D’UN FEU DE GRAISSE DU SOMMET DE LA CUISINIÈRE, OBSERVER LES SUIVANTS: SEULEMENT Page 5...
- Page 6 Parts Included with your Parts Not Included with Hood your Hood • Page 6...
-
Page 7: Before Installing Hood
BEFORE INSTALLING HOOD CAUTION: Page 7... - Page 8 BEFORE INSTALLING HOOD APPLIANCE INSTALLATION CABINET OR SOFFIT PREPARATION Cabinet Front Bottom of Cabinet or Soffit Cabinet Vertical Discharge 4-1/2" 9" 4-3/8" 12" 1/2" 1/2" 5-7/8" (HS-HSB) 1-7/8" (HS-HSB) 2-1/16" 1-1/2" 4-7/8" 4-3/4" (HST) (HST) Dia. Holes 20" Optional Rear Rear Discharge Wall...
-
Page 9: Typical Installation
BEFORE INSTALLING HOOD TYPICAL INSTALLATION The height from the countertop to the bottom of the hood is 30" to 36”.These hoods recommended to be used over indoor grills. DUCTING Note - Horizontal Discharge: Page 9... - Page 10 BEFORE INSTALLING HOOD plate Discharge Direction: fixing point Plate Note: Figure 3 Assembly of the Transition: Tongue Transition Top outlet Figure 4 Page 10...
- Page 11 BEFORE INSTALLING HOOD HOOD WIDTH DIM. "W" DIM. "K" DIM. "Z" Wall Mount Installation - 30" 29 - 1/8" 2 - 1/2" 7 - 1/16" HS and HSB series only. 36" 35 - 1/16" 2 - 1/2" 7 - 1/16" (see Figure 5) 42"...
- Page 12 Wall Mount Installation - HST series Hood only (see Figure 6-7-8) Figure 6 6 7/8” Figure 7 Page 12...
- Page 13 Figure 8 Page 13...
- Page 14 INTEGRAL VENTILATOR Cabinet Installation: INSTALLATION (Figure 5) (Models VTN420B or VTN620B) (see figure 9) figure A Integral ventilator fixing point Motor support bracket Motor connector Figure 9 Page 14...
- Page 15 From Control Wiring the HOOD with an Panel IntegralVentilator: Warning: Figure 9 Figure 10 Motor connector Figure 11 VTN 420 or VTN 620 Figure 10 From control panel Final installation steps Figure 11 Figure 12 Figure 12 Page 15...
- Page 16 REMOTE VENTILATOR INSTALLATION Models VTR600R or VTR1000Q (Only HS and HST Series Hood): Parts Not Included with your Hood Wiring the Hood with a Remote Ventilator: Warning: Ground Figure 13 Page 16...
- Page 17 Assembly and Installation of the Duct Covers (HS and HSB Series Hood only): Fixing Screws (number depends on hood size) Figure 14 Page 17...