Page 1
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: INSTALLER: OWNER: Safety Warning: Turn off power circuit at service panel and lock out panel, before wiring this appliance. Requirement: 120 V AC, 60 Hz. 15 or 20 A Branch Circuit...
IMPORTANT SAFETY INSTRUCTIONS CAUTION: FOR GENERAL VENTI- LATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VA- PORS. WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: CAUTION: To reduce risk of fire and to properly exhaust air, be sure to duct air outside - do not vent exhaust air into spaces...
Page 3
IMPORTANT SAFETY INSTRUCTIONS WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE. WARNING - TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING ONLY...
Page 4
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES ATTENTION: SEULEMENT POUR L’UTILISATION D’AÉRATION. NE PAS L’UTILISER POUR ÉPUISER LA VAPEUR OU LES MATIÈRES EXPLOSIVES OU DANGEREUSES. AVERTISSEMENT RÉDUIRE D’INCENDIE, ÉLECTRIQUE, BLESSURE AUX PERSONNES, OB- SERVER LE SUIVANT: POUR RISQUE CHOC ATTENTION: Pour réduire le risque d’incendie, utiliser seulement le travail du conduit métallique.
Page 5
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES AVERTISSEMENT RÉDUIRE LE RISQUE D’UN FEU DE GRAISSE DU SOMMET DE LA CUISINIÈRE: POUR AVERTISSEMENT: RÉDUIRE BLESSURE AUX PERSONNES DANS L’ÉVÉNEMENT D’UN FEU DE GRAISSE DU SOMMET DE LA CUISINIÈRE, OBSERVER LES SUIVANTS: SEULEMENT POUR RISQUE...
Page 6
Parts Included with your Hood • Parts Not Included with your Hood...
BEFORE INSTALLING HOOD TYPICAL INSTALLATION The height from the countertop to the bottom of the hood is 30" to 36”.These hoods recommended to be used over indoor grills. DUCTING Note - Horizontal Discharge:...
Page 10
BEFORE INSTALLING HOOD Discharge Direction: Note: Figure 3 Assembly of the Transition: Figure 4...
Page 11
BEFORE INSTALLING HOOD Wall Mount Installation - HS and HSB series only. (see Figure 5) 7- 1/2” 1 2 - 5 / 8 ” HOOD WIDTH DIM. "W" DIM. "K" DIM. "Z" 30" 29 - 1/8" 2 - 1/2" 7 - 1/16" 36"...
Page 12
Wall Mount Installation - HST series Hood only (see Figure 6-7-8) Figure 6 6 7/8 Figure 7...
Page 14
Cabinet Installation: (Figure 5) INTEGRAL VENTILATOR INSTALLATION (Models VTN420B or VTN620B) (see figure 9) figure A Figure 9...
Page 15
Wiring the HOOD with an IntegralVentilator: Warning: Figure 10 Figure 11 Final installation steps Figure 9 Figure 10 Figure 11 Figure 12 Figure 12...
Page 16
REMOTE VENTILATOR INSTALLATION Models VTR600R or VTR1000Q (Only HS and HST Series Hood): Included with your Hood Wiring the Hood with a Remote Ventilator: Warning: Parts Not Figure 13 Ground...
Page 17
Assembly and Installation of the Duct Covers (HS and HSB Series Hood only): Figure 14...