Table of Contents
Advertisement
Figure 52
Spring cover not shown
1. Idler-pulley assembly
5. Remove the belt from the 3 pulleys
Figure 53
Spring cover not shown
6. Install a new drive belt around the 3 pulleys
7. Install the end of the idler-pulley spring to the arm on
the idler-pulley assembly.
Important: If you have removed the spring cover,
ensure to install it over the spring at this time.
8. Using the spring-removal tool, pull the idler spring
hook up and around the stud on the traction unit,
pulling the idler pulley tight.
9. Remove the spring-removal tool from the spring and
close the hood.
2. Drive-belt routing
(Figure
53).
(Figure
Controls System
Maintenance
The factory adjusts the controls before shipping the traction
unit. However, after many hours of use, you may need to
adjust the traction control alignment, the neutral position of
the traction control, and the tracking of the traction control
in the full forward position.
Important: To adjust the controls properly, complete
each procedure in the order listed.
Adjusting the Traction Control
Alignment
If the traction control bar does not rest flush and square
with the reference bar when in the full backward position,
immediately complete the following procedure:
1. Park the traction unit on a flat surface and lower the
loader arm.
2. Shut off the engine and remove the key.
3. Pull straight back on the traction control so the front
of the control contacts the reference bar
1. Front of the control (out of
alignment)
52).
4. If the front of the traction control does not rest square
and flush with the reference bar, loosen the flange nut
and bolt in the stem of the traction control
1. Traction control
39
(Figure
Figure 54
2. Reference bar
(Figure
Figure 55
2. Stem, bolt, and nut
54).
55).
- Quick Links:
- Controls
- Servicing the Engine Oil
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
