Drive Commissioning (Sinamics); Requirements; Basic Requirements - Siemens SINUMERIK 840Di sl Commissioning Manual

Hide thumbs Also See for SINUMERIK 840Di sl:

Table of Contents

Drive commissioning (SINAMICS)

The following basic requirements must be fulfilled for the commissioning of SINAMICS S120.

● The electronic power supply of PG/PC, SINUMERIK 840Di sl and SINAMICS S120 is

● The mechanical and electrical elements of the SINAMICS drives are set up and

● The SINAMICS STARTER drive commissioning tool is installed on the PG/PC. Version:

● PG/PC and SINUMERIK 840Di sl communication via Ethernet.

● SINUMERIK 840Di sl and SINAMICS S120 communication via PROFIBUS.

Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0

switched on.

connected correctly, including DRIVE CliQ connections.

SINAMICS S120, Commissioning Manual, Chapter "Preparations for Commissioning"

At least V4.0

The Ethernet interface of the PG/PC must be connected to the Ethernet 1 interface of the

PCU for this, and the Ethernet communication must be parameterized. See Chapter "PLC

Commissioning" (Page 149)

The PROFIBUS interface (X101) of the MCI board must be connected to the PROFIBUS

interface of SINAMICS S120, and the PROFIBUS communication must be parameterized.

See Chapter "PROFIBUS DP communication" (Page 229).

Show Quick Links

Table of Contents

Sinumerik 840die sl control