hit counter script
  1. Manuals
  2. Brands
  3. Toshiba Manuals
  4. Laptop
  5. Satellite M30
  6. User manual

Toshiba M30 User Manual page 10

Portable personal computer
Hide thumbs Also See for M30:
Table of Contents

Advertisement

Notes for use of this device in New Zealand
The grant of a Telepermit for a device in no way indicates Telecom acceptance
of responsibility for the correct operation of that device under all operating
conditions. In particular the higher speeds at which this modem is capable of
operating depend on a specific network implementation which is only one of
many ways of delivering high quality voice telephony to customers. Failure to
operate should not be reported as a fault to Telecom.
In addition to satisfactory line conditions a modem can only work properly if:
a/
it is compatible with the modem at the other end of the call and
b/
the application using the modem is compatible with the application at the
other end of the call - e.g., accessing the Internet requires suitable
software in addition to a modem.
This equipment shall not be used in any manner which could constitute a
nuisance to other Telecom customers.
Some parameters required for compliance with Telecom's PTC Specifications
are dependent on the equipment (PC) associated with this modem. The
associated equipment shall be set to operate within the following limits for
compliance with Telecom Specifications:
a/
There shall be no more than 10 call attempts to the same number within
any 30 minute period for any single manual call initiation, and
b/
The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next.
c/
Automatic calls to different numbers shall be not less than 5 seconds
apart.
Immediately disconnect this equipment should it become physically damaged,
and arrange for its disposal or repair.
The correct settings for use with this modem in New Zealand are as follows:
ATB0 (CCITT operation)
AT&G2 (1800 Hz guard tone)
AT&P1 (Decadic dialing make-break ratio =33%/67%)
ATS0=0 (not auto answer)
ATS6=4 (Blind dial delay)
ATS7=less than 90 (Time to wait to carrier after dialing)
ATS10=less than 150 (loss of carrier to hangup delay, factory default of 15
recommended)
Show Quick Links

Hide quick links:

Advertisement

Table of Contents
loading

Related Manuals for Toshiba M30

Related Products for Toshiba M30

This manual is also suitable for:

Psm30c-0qq31Psm30c-0ruu9Psm30c-7101uPsm33c-00100ePsm33c-ysj00eSatellite m30 series ... Show all

Table of Contents