hit counter script
Whirlpool 9700 Series Use And Care Manual
Whirlpool 9700 Series Use And Care Manual

Whirlpool 9700 Series Use And Care Manual

Whirlpool dishwasher user manual

Advertisement

Quick Links

-,
TLi+l
of
4a
Home
Appliances
Use & Care Guide
Top rack
adjuster
_
kdjustable
:op rack
Mater inlet opening
lack bumper
Heating
element
Silverware
basket -
4
Cutlery
basket
-
Rinse agent/
t
dispenser
ii
Detergent
A:-------
Extra-capacity
35
fold down shelf
dll
Upper spray arm
Spray
tower
Bottom
rack
POWER CLEAN'"
module
Overfill
protector
c
Model
and
serial
number
label
(on right side)
Door dolor
panel
Lower
I
spray
arm
9700 SERIES DISHWASHERS

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool 9700 Series

  • Page 1 Mater inlet opening lack bumper Heating element Silverware basket - Cutlery basket Rinse agent/ dispenser Detergent A:------- 9700 SERIES DISHWASHERS Home Appliances Extra-capacity fold down shelf Upper spray arm POWER CLEAN’” serial (on right side) Door dolor Lower panel spray...
  • Page 2: Table Of Contents

    Special tips Common Dishwashing Problems If You Need Service Or Assistance Whirlpool Dishwasher Warranty 01992 Whirlpool Corporation Thank you for buying a Whirlpool appliance. Please complete and mail the Owner tration Card provided with this product. Then complete the form below. Have this informa- tion ready if you need service or call with a question.
  • Page 3: Important Safety Instructions

    Important Safety Instructions To reduce the risk of fire, electrical dishwasher, Read all instructions before using the dishwasher. Properly connect to electricity and water. . DISHWASHER MUST BE ELECTRICALLY GROUNDED. Read the Installation Instructions for details. Be sure your dishwasher is installed on a level floor that will hold the weight, and in an area suitable for ils size and use.
  • Page 4: Before Starting Your Dishwasher

    Operating Instructions Continued The drawings in this book may vary slightly from your dishwasher model. They are designed to show the different features of all the models covered by this book. NOTE: Your model may not include all the features shown. Before starting your dishwasher 1.
  • Page 5: Changing A Cycle Setting

    Changing a cycle setting You can change a cycle setting anytime during any cycle. 1. Press the CANCEL pad. The dishwasher will go into a 2-minute drain cycle. 2. Be sure the detergent dispensers are filled properly for the new cycle. 3.
  • Page 6: The Cancel Pad

    Operating Instructions Continued 3. Press the DELAY/PAUSE pad again to select a 1 hour delay. Pressing the pad again adds another hour of delay to the drgital display. NOTE: After “9 delay hours” is selected, pressing the DELAY/PAUSE pad again will display the last selected cycle and options.
  • Page 7: Control Panel Lock-Out Feature

    Control panel lock-out feature A hidden pad is located in the center of the control pads. This pad lets you lock-out the function of all the control pads except the Cancel pad. When the control panel is locked-out, the dishwasher cannot be started and a running cycle cannot be changed.
  • Page 8: Thebeepingsound

    Operating Instructions Continued The beeping sound Each time a control pad is pressed, a single “beep” sound IS made. A double beep means the wrong control pad has been pressed. Three beeps sound at the begrnnrng of the drying part of a cycle. A longer “beep“...
  • Page 9: The Status Indicators

    5 I’ 2. Pressing the SET FAVORITE pad during this 30 seconds will set the cycle and option combination that is showing on the display as your favorite cycle. “FAVORITE SET” will be displayed. Or you may wait until the display goes out and: 3.
  • Page 10 Operating Instructions Continued The PAUSE HEAT indicator The “PAUSE HEAT” indicator and current water temperature will show on the display if the dish- washer needs additional time to heat water in the main wash. The water heating will continue until either the water reaches a temperature between 135°F and 140°F (57°C and 60%) or a preset time-limit is up.
  • Page 11 During a cycle, the “HEATING” indicator shows when the water in the dishwasher is being heated. In the Pots 8 Pans Cycle or any cycle using the Hi-Temp Option, the “HEATING” indicator and water temperature will be displayed several times if the water needs additional time to be heated.
  • Page 12: What Happens In Each Cycle

    Operating Instructions Continued What happens in each cycle Pots & Pans Cycle A double wash with maximum cleaning for cooked-on or baked-on foods. Cycle time’ is about 73 minutes plus the time needed while the timer delays to heat the water (marked t) to 140°F (60°C) in both washes and the last rinse.
  • Page 13 Normal Cycle A single wash for normal, everyday soiled loads. (The Energy Guide Label is based on this cycle.) Cycle time* is about 66 minutes plus the time needed while the timer delays to heat the water to 140°F (60%) in the wash (marked 7) and, if the Hi-Temp Option is selected, in the last rinse (marked tt).
  • Page 14 Operating Instructions Continued China Cycle A single light wash and gentle dry for china and crystal. The heating element cycles on and off during the “dry” part of the cycle when the Heat Dry Option is selected. Cycle time* is about 59 minutes.
  • Page 15: What Happens In Each Option

    What happens in each option Options can be selected by pressing the OPTIONS pad. Each press of the pad advances the selection to the next option. You can select Heat Dry, Heat Dry and Hi-Temp, Air Dry, or Air Dry and Hi-Temp.
  • Page 16: Proper Loading

    Proper Loading Cup and glass load Mixed load Preparation for loading It is not necessary to rinse dishes before putting them into the dishwasher. Just remove large pieces, bones and other hard items. The POWER CLEAN” Module will remove food particles from the water.
  • Page 17 Extra-capacity fold down shelf An extra shelf on the right side of the top rack can be folded down over short items (cups, juice glasses, cereal bowls, etc.) to hold extra items. Adjust rack height if necessary (see below). To avoid chipping, do not let stemware touch other items.
  • Page 18 Proper Loading Continued Fold down divider A fold down divider at the back of the rack can be lowered to make room for deep bowls, roasters. etc. Silverware basket loading Load forks and spoons so they don’t nest together. Spray can’t reach nested items. Mix items in each section of the basket.
  • Page 19: Adding Detergent

    Adding Detergent Liquid dishwasher detergent dishwasher ’ detergent See phosphorus content on product labels. Cover Cover Latch Use both sections for... Pots & Pans Cycle Heavy Cycle Use open section Low Energy Cycle China Cycle What kind of detergent to use ,Use automatic dishwasher Other detergents are too mild and much too sudsy...
  • Page 20: Using Rinse Agent Dispenser

    Using Rinse Agent Dispenser some models Keep rinse agent dispenser filled f Rinse agent dispenser Keep the rinse agent dispenser filled with a liquid rinse agent such as Jet-Dry.” A rinse agent greatly improves the drying of dishes helping water flow off of them during last rinse.
  • Page 21: For Best Results

    For Best Results Hot water is a must Hot water dissolves and activates the dishwashing detergent. Hot water dissolves grease on dishes and helps dry glasses spot-free. Make certain loads are washed in hot water. Two ways to have a reliable hot water supply.. 1.
  • Page 22 For Best Results Continued Energy saving tips You can help save energy if you: 1. Wash full loads. Running a half-filled dish- washer uses the same amount of electricity and hot water as a fully loaded machine. 2. Use the Low Energy Cycle whenever possible.
  • Page 23: Common Dishwashing Problems

    Dishwashing Problems Common Spotting and filming Hard water Fill detergent dispensers to capacity. Use dishwasher detergent with highest available phosphorus content. May be necessary to install water softener. TO remove spots and film, try a vinegar rinse... 1. Wash and rinse load as usual. Use Air Dry Option.
  • Page 24 Common Dishwashing Problems Continued Dishes not washing clean Water is not hot enough Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting and/or use Hi-Temp Option. Improper loading Make sure dishes and glassware are loaded...
  • Page 25: If You Need Service Or Assistance

    If dishes aren’t as dry as you expected: Is the rinse agent dispenser filled? Using a rinse agent greatly improves drying. (See page 20.) 2. If you need assistance*... Call Whirlpool Consumer telephone number. Dial free from anywhere in the U.S.: l-800-253-1301 and talk with one of our trained consultants.The...
  • Page 26 Whirlpool appliance. To locate FSP replacement parts in your area, refer to Step 3 above or call the Whirlpool Con- sumer Assistance Center number in Step 2. 5. If you are not satisfied with how the problem was solved*...
  • Page 27 POWER CLEAN” washing system parts covered by your warranty spray arm L&wer spray arm POWER CLEAN module and motor...
  • Page 28: Whirlpool Dishwasher Warranty

    C. Pickup and delivery. This product is designed to be repaired in the home. D. Damage to dishwasher caused by accident, misuse, fire, flood, acts of God or use of products not approved by Whirlpool. E. Any labor costs during limited warranties.

Table of Contents