Effect With Negative Compensation Values - Siemens SINUMERIK 880 Programming Manual
Hide thumbs
Also See for SINUMERIK 880:
- Installation operation & maintenance (34 pages) ,
- Installation manual (4 pages) ,
- Planning manual (375 pages)
Table of Contents
Advertisement
10 Cutter Radius Compensation (CRC), Tool Nose Radius Compensation (TNRC)
05.91
10.11 Effect with negative compensation values
10.11 Effect with negative compensation values
If the compensation value is negative, cutter radius P4, a compensated path corresponding to
G42 with a positive compensation value is implemented with G41, i.e. an analog internal con-
tour is followed instead of the programmed external contour, and vice versa.
In the cutter centre path shown in the diagram below (a) a positive compensation value has
been entered. A negative compensation value in conjunction with the same machining program
will effect the machining shown on the right of the diagram (b).
(a)
(b)
If the program is written as shown in (b) with a positive compensation value, a negative com-
pensation value will effect machining as shown in (a). The two operations are distinguished by
entering a positive or negative compensation value.
10–18
© Siemens AG 1991 All Rights Reserved
6ZB5 410-0HD02
SINUMERIK 880, (PG)
Advertisement
Table of Contents
