Table of Contents
Advertisement
Configuring Not to Detect Certain Overlap Patterns
If detecting overlapped documents during a scan has been set, when you load a document that has paper
attached to it such as a sticky note, receipt, or a photo in the ADF paper chute (feeder) and scan it, it is
detected as an overlapped document, and the scan may stop. Use the intelligent multifeed detection function
not to detect these types of documents.
This function has two modes, a mode that is used to configure the settings manually by a user every time the
scanner detects overlapped documents, and a mode that is used to configure the settings automatically by the
scanner based on the overlap patterns (length and location) for paper attachments such as sticky notes,
receipts, or photos that the scanner has memorized.
To use this setting, detecting overlapped documents needs to be set in advance.
● [Multifeed Detection] in the scanner driver
For details, refer to the help for the scanner driver.
● [Multifeed] in the Software Operation Panel
For details, refer to
The following three operation modes are available.
Operation Mode
Manual mode
Auto mode 1
(Bypass by combination of length and
position)
Auto mode 2
(Bypass by length)
Select the operation mode in the Software Operation Panel.
For details, refer to
Setting to Ignore Certain Overlap Patterns [Intelligent Multifeed Function] (page
Specifying a Method to Detect Overlapped Documents [Multifeed] (page
Description
Specify whether or not to detect overlapped documents every
time they are detected.
Specify the setting not to automatically detect overlapped
documents when the paper attachment is the same length and
in the same location as memorized.
Specify the setting not to automatically detect overlapped
documents when the paper attachment is the same length or
shorter as memorized.
80
Various Ways to Scan
182).
191).
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
