Table of Contents
Advertisement
1.5
Displays and Operator Controls of the CP 343-2
The following diagram shows the front panel of the CP 343-2 with its indicators and
operator controls. The front connector for connecting the AS-i cable is below the
cover on the front of the CP 343-2.
AS-i+ (brown)
AS-i− (blue)
Contacts 17, 19 and 18, 20 are jumpered internally on the CP 343-2.
Figure 1-3
Front Connector Pin Assignment and Labeling on the CP 343-2
The CP 343-2 has internal contacts for two AS-i cables that are jumpered internally
on the CP. This allows the CP 343-2 to be "looped" into the AS-i cable.
Notice
The load capacity of the contacts is a maximum of 4 A. If this value is exceeded
on the AS-i cable, the CP 343-2 must not be "looped into" the AS-i cable but must
be connected by a separate cable (only one pair of contacts used on the
CP 343-2).
For further information on connecting the AS-i cable, refer to Section 2.2.
CP 343−2 / CP 343−2 P AS−Interface Master
Release 08/2008
C79000−G8976−C149−04
SF
RUN
APF
CER
AUP
CM
B
20+
10+
SET
9
8
7
6
5
4
3
17
2
18
1
19
0
20
1 Technical Description
17
Hide quick links:
Advertisement
Chapters
Table of Contents
