Installation Procedure - HP 98568A Installation Instruction
Hp 9000 series 300 computers
Hide thumbs
Also See for 98568A:
- Service information manual (142 pages) ,
- Service information manual (144 pages)
Table of Contents
Advertisement
HP 45911 A Graphics Tablet
Installation Procedure
Note
Connecting and disconnecting
HP-HIL
devices while some
language/ operating systems or application programs are
running may lead to unpredictable results. When possible,
connect all needed
HP-HIL
devices to your computer before
booting a language/operating system or running an application
program.
1. Find the
HP-HIL
cable that came with the tablet.
2. Find the end of the cable that is marked with one black dot.
3. Find the
HP-HIL
connector on the tablet that is marked with one dot.
4. Plug the "one-dot" end of the cable into the "one-dot" connector on the
tablet.
5. Connect the other, "two-dot" end of the cable into the
HP-HIL
connector on
your computer (marked "KYBD" or "KEYBOARD"), or to the "two-dot"
connector of the last
HP -HIL
device you installed (e. g. key board).
6. Plug the stylus into the telephone jack on the tablet.
7. Keep these constraints in mind:
• You cannot have more than 7
HP-HIL
addressable devices connected to
your computer at one time. The
HP
460S0A, 460S1A, 460S2A and 460S2B
Extension modules and the
HP
460S9A Four-Button Cursor do not count
as addressable devices, and the
HP
460S5A Control Dials Module counts
as three addressable devices. All other devices count as one addressable
device .
• The current requirements of all of your devices must not exceed 750
milliamps (rnA). To make sure you do not exceed this requirement, total
up the typical power required by each of your
HP-HIL
devices as given in
the following "Worksheet Entries" sections. If the total exceeds 750 rnA,
you must remove one or more devices.
Adding Miscellaneous Peripherals
10-17
- Quick Links:
- Table of Contents
- Getting Started
- Description
Hide quick links:
Advertisement
Chapters
Table of Contents
