Advertisement
Quick Links
IBM storage products
Quick installation guide
Ultrastar 36XP
Multi-mode SE/LVD
Models: DRHS-36V
DRHS-36D
Handling precautions
1. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic
discharge (ESD).
2. Do not open the static-protective bag containing the
drive until required. Static electricity can damage the
drive.
3. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic dis-
charge (ESD).
4. Do not open the static-protective bag containing the
drive until required. Static electricity can damage the
drive.
5. Turn off and unplug your computer. Remove case.
6. When you are installing the drive, touch the
static-protective package containing the drive to a
grounded, unpainted metal surface for at least two
seconds. (This drains static electricity from the
package and from your body.)
7. Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
8. Save your drive packaging materials including the
ESD bag in the event that the drive must be returned.
Place the drive in an anti-static bag before placing it in
the shipping container. The warranty will be void if
the drive is not returned in IBM approved packaging.
Installation procedure
It is advisable to back up all data before proceeding
with the installation.
IBM Hard Disk Drive Technical Support Center
This procedure may require the use of a bootable
System Diskette containing FDISK.COM and
FORMAT.COM
Setting the address
1. Each drive on the SCSI bus must have a unique
address. Sixty eight and eighty pin (Wide SCSI) de-
vices have 16 possible addresses.
2. SCSI address bits 3,2,1, and 0 of the 32 pin Option
Jumper Block are used to select the SCSI device ID.
External Activity LED Write Protect
Ground
Auto Start
Blank
Reserved
SCSI ID
Bits
3
2
1
0
1 3
5
7
11 13 15 17 19 21 23 25 27 29 31
10 12 14 16 18
2 4
6
8
Ground
Ground
Reserved
Note: In the table below, "off" means a jumper is not
in place and "on" means a jumper is in place.
Bit 3
Bit 2
off
off
off
off
off
off
off
off
off
on
off
on
off
on
off
on
on
off
on
off
on
off
on
off
on
on
on
on
on
on
on
on
Page 1
Force Single Ended Mode
Auto Start Delay
Disable Sync Negotiations
Disable SCSI Parity
Disable Unit Attention
Disable Wide
Negotiations
20 22 24 26 28 30 32
+5V
Ground
Termination
Power Enable
Bit 1
Bit 0
Address
off
off
0
off
on
1
on
off
2
on
on
3
off
off
4
off
on
5
on
off
6
on
on
7
off
off
8
off
on
9
on
off
10
on
on
11
off
off
12
off
on
13
on
off
14
on
on
15
version 2.0
Advertisement
Related Manuals for IBM Ultrastar 36XP
Summary of Contents for IBM Ultrastar 36XP
- Page 1 Place the drive in an anti-static bag before placing it in the shipping container. The warranty will be void if the drive is not returned in IBM approved packaging. Installation procedure It is advisable to back up all data before proceeding with the installation.
- Page 2 Questions regarding IBM’s warranty terms or 3. Follow the Setup menu to configure your computer methodology used to derive this data should be referred to the IBM Hard Disk Drive Technical Support Center. Data subject to change without notice.