Table of Contents
Advertisement
Chapter 5. Connecting to an Ethernet Network
This chapter explains how to connect the adapter to the UTP network. Refer to your local procedures for
information about connecting the 10/100/1000 Base-TX Ethernet PCI-X Adapter or Dual Port 10/100/1000
Base-TX Ethernet PCI-X Adapter to your Ethernet network.
Note: Only one type of network can be attached to the adapter card at one time.
Connecting the Network Cables and Adapter
Before you begin connecting the adapter, make sure you have the hardware listed in "Verifying Your
Hardware Requirements" on page 3.
To connect the adapter to an unshielded twisted-pair (UTP) network, do the following:
1. Insert the RJ-45 jack of the UTP cable into the RJ-45 connector on the adapter.
2. Insert the RJ-45 jack of the other end of the UTP cable into the network switch.
1
2
3
1. RJ-45 Connector
2. RJ-45 Jack
3. Unshielded Twisted-Pair (UTP) Cable
11
Advertisement
Table of Contents
