Table of Contents
Advertisement
• Directive 2011/65/EU
SINAMICS S devices comply with the requirements of Directive 2011/65/EU on the
restriction of the use of certain hazardous substances in electrical and electronic devices
(RoHS II).
• European EMC Directive
SINAMICS S devices comply with the EMC Directive 2014/30/EU.
• Quality systems
Siemens AG employs a quality management system that meets the requirements of ISO
9001 and ISO 14001.
Standards that are not relevant
China Compulsory Certification
SINAMICS S devices do not fall in the area of validity of the China Compulsory Certification
(CCC).
1.6
Additional information
Ensuring reliable operation
The manual describes a desired state which, if maintained, ensures the required level of
operational reliability and compliance with EMC limit values.
Should there be any deviation from the requirements in the equipment manual, appropriate
actions (e.g. measurements) must be taken to check/prove that the required level of
operational reliability and compliance with EMC limit values are ensured.
Spare parts
Spare parts are available on the Internet at the following address
(https://support.industry.siemens.com/sc/de/en/sc/2110).
Product maintenance
The components are subject to continuous further development within the scope of product
maintenance (improvements to robustness, discontinuations of components, etc).
These further developments are "spare parts-compatible" and do not change the article
number.
In the scope of such spare parts-compatible further developments, connector/connection
positions are sometimes changed slightly. This does not cause any problems with proper use
of the components. Please take this fact into consideration in special installation situations
(e.g. allow sufficient clearance for the cable length).
Air-Cooled Chassis Power Units - supplement to Motor Module 6SL3320-1TG41-5AA3
Equipment Manual, 10/2020, A5E50422764A
Introduction
1.6 Additional information
11
Advertisement
Table of Contents
