Advertisement
Quick Links
Installation
Precautions
• Choose the installation location carefully so that the unit does not hamper the driver during driving.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct
sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 20°.
How to Detach and Attach the Front Panel
Before installing the unit, detach the front panel.
To detach
Press the RELEASE button to open up the front panel, and slide the front panel a little to the left. Then pull
it off towards you.
To detach
RELEASE button
Mounting Example
Installation in the dashboard
1
1 8 2
m m
5 3 m
m
1
Mounting the Unit in a Japanese Car
This unit may not be installed in some makes of cars. In this case, consult your nearest Sony dealer.
1
2
TOYOTA
Run a blade along the slits
on the back of the front trim
and cut it off the unit.
6
max. size
M5 × 8
Slit
Note for Connecting
If there is alternator noise (a whining sound when raising engine speed), earth the master unit by
connecting it to a metal point of the car with the supplied chassis earth cord 8. Connect the ground
cord to the master unit with part 2 as shown in the illustration. (In case you do not use part 2, take
screw 7 instead.)
Reset Button
When the installation and connections are over, be sure to press the reset button with a ball-point pen etc.
To attach
Apply the right hand side of the front panel to the unit by attaching part A of the front panel to part
B of the unit as illustrated, then swing the left side into the unit until it clicks.
To attach
2
3
Bend these claws, if necessary.
to dashboard/center console
6
max. size
M5 × 8
Bracket
Bracket
Existing parts supplied to your car
2
SONY XR-C117 (E) 3-@@@-@@@-11 (1)
Reset button
A
B
Fire wall
Dashboard
2
3
NISSAN
to dashboard/center console
6
max. size
M5 × 8
Bracket
Bracket
Existing parts supplied to your car
to a metal point of the car
8
FM/AM
Cassette Car
Stereo
Installation/Connections
XR-C117
Sony Corporation © 1996
Parts for Installation and Connections
The numbers in the list are keyed to those in the instructions.
2
1
× 1
4
5
× 1
6
max. size
M5 × 8
7
8
× 1
The release key 4 is used for dismounting the unit. See the operating instructions manual for details.
3-858-376-11 (1)
Printed in Indonesia
3
× 1
× 1
6
× 1
× 4
× 1
Advertisement
Related Manuals for Sony XR-C117
Summary of Contents for Sony XR-C117
- Page 1 The numbers in the list are keyed to those in the instructions. Mounting the Unit in a Japanese Car This unit may not be installed in some makes of cars. In this case, consult your nearest Sony dealer. × 1 ×...
- Page 2 SONY XR-C210 (E,S,C) 3-800-373-71 (1) Connections Connections Example Caution • This unit is designed for negative ground 12 V DC operation only. • Before making connections, disconnect the ground terminal of the car battery to avoid short circuits. • Connect the yellow and red power input leads only after all other leads have been connected.