Table of Contents
Advertisement
Available languages
Available languages
11.2 Troubleshooting
Problem
The tumble dryer is not connec‐
ted to the mains supply.
The door is open.
The tumble dry‐
The
er does not op‐
was not pushed.
erate.
The
not touched.
The appliance is in standby
mode.
Incorrect programme selection.
The filter is clogged.
tion was set to
geltrocken) .
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidi‐
ty sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possi‐
After a cycle starts it is not possi‐
ble to change
ble to change the programme or
the programme
option.
or option.
It is not possi‐
The option you tried to select is
ble to select an
not available for the selected
option. An
programme.
acoustic signal
is emitted.
Possible cause
On/Off (Ein/Aus) button
Start/Pause button was
Dryness (Trockengrad) op‐
iron dry (Bü‐
3)
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box
(domestic installation).
Close the door.
Push the
On/Off (Ein/Aus)
button.
Touch the
Start/Pause but‐
ton.
Push the
On/Off (Ein/Aus)
button.
Select a suitable programme.
2)
Clean the filter.
Change
Dryness (Trocken‐
grad) option to a higher level.
Do not exceed the maximum
load size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi‐
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
ENGLISH
23
1)
4)
2)
Advertisement
Chapters
Table of Contents
