Table of Contents
Advertisement
Available languages
Available languages
Problem
Water flows into the refrig-
erator.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
8.2 Replacing the lamp
Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
3. Replace the used lamp with a new
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Make sure that food prod-
ucts do not touch the rear
plate.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if nec-
essary.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
"Installation".
door gaskets. Contact the Service
Center.
ENGLISH
11
Advertisement
Chapters
Table of Contents
