Table of Contents
Advertisement
v An electrical outlet that is not correctly wired could place hazardous voltage on
CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures
v Do not install a unit in a rack where the air flow is compromised. Ensure that
v Consideration should be given to the connection of the equipment to the
v (For sliding drawers) Do not pull out or install any drawer or feature if the rack
v (For fixed drawers) This drawer is a fixed drawer and should not be moved for
(R001)
xiv
TS2230 Tape Drive Setup, Operator and Service manual
the metal parts of the system or the devices that attach to the system. It is the
responsibility of the customer to ensure that the outlet is correctly wired and
grounded to prevent an electrical shock.
will exceed the manufacturer's recommended ambient temperature for all your
rack mounted devices.
air flow is not blocked or reduced on any side, front, or back of a unit used
for air flow through the unit.
supply circuit so that overloading of the circuits does not compromise the
supply wiring or overcurrent protection. To provide the correct power
connection to a rack, refer to the rating labels located on the equipment in the
rack to determine the total power requirement of the supply circuit.
stabilizer brackets are not attached to the rack. Do not pull out more than one
drawer at a time. The rack may become unstable if you pull out more than
one drawer at a time.
servicing unless specified by the manufacturer. Attempting to move the
drawer partially or completely out of the rack may cause the rack to become
unstable or cause the drawer to fall out of the rack.
Advertisement
Table of Contents
