Table of Contents
Advertisement
1
2
005719
2.
Pull the trigger first and then place the contact
element against the workpiece.
No. 1 method is for intermittent nailing, when you
•
wish to drive a nail carefully and very accurately. No.
2 method is for continuous nailing.
For No. 1 method, set the change lever to the
•
"Intermittent Nailing" position.
For No. 2 method, set the change lever to the
"Continuous Nailing" position.
After using the change lever to change the nailing
method, always make sure that the change lever is
properly set to the position for the desired nailing
method.
CAUTION:
However when the tool is set to the "Intermittent
•
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to
re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, perform
as follows;
A.
Do not place the contact element against the
workpiece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailing.
1. Trigger
2. Contact element
3. Workpiece
3
Nailing mode change and trigger locking method
1
2
005720
For continuous nailing, set the change lever to the
"Continuous Nailing" position. For intermittent nailing, set
the change lever to the "Intermittent Nailing" position. To
lock the trigger, set the change lever to the "Trigger Lock"
position. Always make sure that the change lever is
properly set to the position.
CAUTION:
Operating the tool without nails shortens the life of
•
the tool and should be avoided.
Air exhaust
005721
Air exhaust direction can be changed easily by rotating
the exhaust cover. Change it when necessary.
Jammed nailer
005722
7
1. Change lever
2. Continuous
nailing
3. Trigger lock
4. Intermittent
nailing
3
4
1. Exhaust cover
1
1. Hammer
1
2. Small rod
2
Advertisement
Table of Contents
