Table of Contents
Advertisement
only when your home photovoltaic
system can provide sufficient energy
or the energy tariff is good.
Requirements
¡ The smart energy system (energy
manager) must use the EEBus Initi-
ative communications standard.
¡ You have read about how to con-
nect your appliance to the smart
energy system (energy manager)
in the instruction manual for the
smart energy system (energy man-
ager).
Press and hold
1.
for approx. 3 seconds.
Select energy mngmt..
2.
Select Connect.
3.
Confirm the message in the dis-
4.
play.
a The appliance is connected to the
smart energy system (energy man-
ager)
a If the appliance has connected to
the energy manager successfully,
the display shows .
Activate Flex Start if you want the
5.
smart energy system (energy man-
ager) to start up your appliance.
→ "Activate Flex Start", Page 55
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement: The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
Set the programme you require.
1.
Press Finish in to set the required
2.
time.
Remote Start
Press Start/Reload
3.
a The display shows Delayed start.
Press
Remote Start .
4.
a If the display shows Flex Start,
Flex Start is activated and the ap-
pliance waits to be started by the
smart energy system (energy man-
ager).
a If the display changes to : Ready
in approx., the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡ Press Start/Reload
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
16.5 Activating Wi-Fi on the
appliance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold
1.
for approx. 3 seconds.
Select Wi-Fi On/Off.
2.
Select on.
3.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Home Connect en
.
.
Remote Start
55
Advertisement
Table of Contents
