Fit Battery Cover Onto Bosch Powertube 500 Battery (Horizontal) - Bosch ZEMO SU-E FS 12 Translation Of Original Operating Instructions
Pedelecs with intuvia on-boad computer
Hide thumbs
Also See for ZEMO SU-E FS 12:
- Translation of original operating instructions (299 pages)
Table of Contents
Advertisement
5.3.2.3 Fit battery cover onto Bosch PowerTube 500 battery (horizontal)
Only applies to pedelecs with this equipment
1 Detach upper interface (lock side) from the
BOSCH PowerTube 625 battery with a
TORX® T20 wrench.
Figure 60: Detaching the upper interface
2 Fasten PowerTube extension to the BOSCH
PowerTube 500 battery using the two
M4 x 8 T20 screws supplied. In doing so,
ensure that the closed side faces the front of
the battery, towards the battery On-Off button.
The smooth upper surface of the PowerTube
extension must face upwards, away from the
battery.
Figure 61: Fitting the PowerTube extension
MY22Z01 - 12_1.0_25.07.2022
3 Screw the battery mounting plate onto
PowerTube extension with original BOSCH
screws (M4 × 8 T20). To do so, use PowerTube
extension screw plate as counter support.
When positioning the extension, ensure that
the removal tab faces the front of the battery.
Figure 62: Fastening the battery mounting plate
4 Press to push the battery cover onto the
battery. In doing so, ensure that the battery
On-Off button fits through its designated slot in
the cover.
The battery cover will lock into the fitting
grooves on the battery.
Figure 63: Pushing the battery cover onto battery
Insert battery into the frame.
Assembly
72
Advertisement
Table of Contents
