Table of Contents
Advertisement
Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
2 Removing and Installing / 2.3 Installing the turbocharger
2.3.3
Attaching the turbocharger to the bracket
Fig. 9: Placing the turbocharger on the bracket
Product
Through hole in
bearing casing [mm]
TPS44
TPS48
TPS52
Table 5: Tightening torque for turbocharger fixing screws
1. Make sure that covers of the oil and water connections are removed.
2. Make sure that the gaskets are not damaged and are positioned correctly in the slots.
3. Install the swivel lifting eye (S) and attach the lifting gear to it.
4. Align the turbocharger over the threaded rods of the bracket.
5. Place the turbocharger on the bracket.
6. Lightly oil the hexagon nuts.
7. Fit the hexagon nuts. Observe the tightening torque.
8. Connect cable to speed sensor (86505).
Remove the lifting gear.
u
Connect all the gas pipes and air lines according to the enginebuilder's instructions.
u
If the gas outlet casing from ABB has not been dismantled with the turbocharger, refer to
u
chapter
Installing the gas outlet casing
Fit the water pipes according to the instructions of the enginebuilder.
u
© Copyright 2017 ABB. All rights reserved.
Fixing screws [mm]
Ø 17
Ø 17
Ø 20
→68.
HZTL4037_EN
Tightening torque [Nm]
(assumed friction coeffi-
M16
M16
M20
Revision E
cient µ = 0.12)
280
280
560
July 2017
Advertisement
Chapters
Table of Contents
