Setting The Mechanical Stop Of Joint #3 - Epson LS-B Series Manual
Industrial robot: scara robot
Hide thumbs
Also See for LS-B Series:
- Safety and installation (126 pages) ,
- Maintenance manual (364 pages)
Table of Contents
Advertisement
LS10-B Manipulator 5. Motion Range
5.2.2 Setting the Mechanical Stop of Joint #3
This method applies only to the Standard-model manipulator.
NOTE
For the Cleanroom-model
changed.
(1) Turn ON the Controller and turn OFF the motors using the Motor OFF command.
(2) Push up the shaft while pressing the
NOTE
(3) Turn OFF the Controller.
(4) Loosen the lower limit mechanical stop screw (set screws: 2-M5×6).
NOTE
(5) The upper end of the shaft defines the maximum stroke. Move the lower limit
(6) Firmly tighten the lower limit mechanical stop screw (set screws: 2-M5×6).
(7) Turn ON the Controller.
116
the motion range set with the Joint #3 mechanical stop cannot be
,
brake release switch.
Do not push the shaft up to its upper limit
or it will be difficult for the arm top cover
to be removed. Push the shaft up to a
position where the Joint #3 mechanical
stop can be changed.
When you press the brake release switch, the shaft may lower due to the weight of the
end effector. Be sure to hold the shaft by hand while pressing the button.
A mechanical stop is mounted on both the top and bottom of Joint #3. However,
only the position of the lower limit mechanical stop on the top can be changed
Do not remove the upper limit mechanical stop on the bottom because the calibration
point of Joint #3 is specified using the stop.
mechanical stop down by the length you want to limit the stroke.
For example, when the lower limit mechanical stop is set at "200 mm" stroke, the
lower limit Z coordinate value is " 200". To change the value to " 180", move
the lower limit mechanical stop down "20 mm".
distance when adjusting the mechanical stop.
Recommended tightening torque: 3.9 N·m (39.8 kgf·cm)
Use calipers to measure the
Measure this
distance
Brake release switch
Lower limit mechanical
stop screw
Set screw: 2-M5×6
Shaft
LS-B series Rev.5
Advertisement
Table of Contents
