Table of Contents
Advertisement
Setting the Diskette Drive[s)
Your system probably came with a 3.5-inch diskette drive or a
5.25/3.5-inch combination drive installed. You may also have
another drive of a different size or capacity.
Check the settings for both drives and correct them if
necessary. (If you have only one diskette drive or if you install
a drive that isn't attached to the diskette drive connector on the
system board, select Not Installed for drive B.) If you
install a combination diskette drive, the top drive is A and the
bottom drive is B.
Setting the Hard Disk Drive[s)
The SETUP program lets you select the type of hard disk
drive(s) installed in your computer. If you have two hard disk
drives, the first one is C and the second one is D. Be sure to
choose the correct setting for both drives.
Check the hard disk drive table in Appendix A to identify the
hard disk drive type for your drive. If you have an EPSON-
supplied hard disk drive, see the final column of this table for
your hard disk drive. Then enter the drive type that
corresponds to your drive.
If the parameters for your hard disk drive are not included in
this table, you need to define your own drive type. See the next
section for instructions on defining your own drive type.
Running the SETUP Program
2 - 5
Advertisement
Table of Contents
