Table of Contents
Advertisement
1.
REPLACEMENT OF VERMICULITE
Vermiculite is a naturally occurring aluminium-magnesium
silicate material that is non-toxic and environmentally
friendly. The purpose of the vermiculite bricks in the
appliance is to promote a higher internal temperature
resulting in a longer burn time and greater efficiency. Over
time the vermiculite may become cracked and crumble
away. If so, then it should be replaced soon after.
To replace the vermiculite lining:
1.
Move any ash away from the base of the bricks.
2.
Remove the brick retainer and remove the bricks.
Replace the vermiculite bricks into the firebox as shown
in the diagram. Ensure vermiculite bricks are placed in the
order listed below.
1.
Two large bricks with one angled edge - one
on either side of the firebox. Place angled edge
towards the back of the firebox, and slide towards
the front to tuck behind brick retainers bolted to
sides of firebox.
2.
Two medium bricks with two angled edges - one
on either corner of the firebox. Ensure angled cut
meets up neatly with side bricks.
3.
One small brick at the rear - this should slot right
into place.
Once bricks are in, fit the retainer over the top to hold them
in place.
MAINTENANCE AND SERVICING
BRICK RETAINER
1
2
3
2
1
7
Advertisement
Table of Contents
