hit counter script

Drive System Maintenance; Servicing The Tracks - Toro 22327 Operator's Manual

Compact tool carrier
Hide thumbs Also See for 22327:
Table of Contents

Advertisement

Drive System
Maintenance

Servicing the Tracks

Service Interval: After the first 8 hours—Check and
adjust the track tension.
Every 50 hours—Check and adjust the track
tension.
Before each use or daily—Clean the tracks.
Before each use or daily—Check the tracks for
excessive wear and proper tension.
Cleaning the Tracks
1.
Park the machine on a level surface and engage
the parking brake.
2.
With the bucket installed and pointing down,
lower it into the ground so that the front of the
traction unit lifts off the ground a few centimeters
(inches).
3.
Shut off the engine and remove the key.
4.
Using a water hose or pressure washer, remove
dirt from each track system.
Important:
Ensure that you use high-pressure
water to wash only the track area. Do not use
a high-pressure washer to clean the rest of the
traction unit. Do not use high pressure water
between the drive sprocket and the traction unit or
you may damage the motor seals. High-pressure
washing can damage the electrical system and
hydraulic valves or deplete grease.
Important:
Ensure that you fully clean the road
wheels, the front wheel, and the drive sprocket
(Figure
55). The road wheels should rotate freely
when clean.
Figure 55
Wide track shown
1. Track
2. Front wheel
g029756
3. Drive sprocket
4. Road wheel
Adjusting the Track Tension
Machines with Narrow Tracks
Lift/support 1 side of the machine and using the weight
of the track, verify that the gap between the bottom
of the lip of the road wheel and the track is 13 mm
(1/2 inch) as shown in
track tension using the following procedure.
1. Road wheel
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine and remove the key.
3.
Raise the side of the machine that you are
adjusting so that the track is off the ground.
4.
Remove the locking bolt, spacer, and nut
57).
1. Locking bolt
2. Tensioning screw
40
Figure
56. If it is not, adjust the
Figure 56
Figure 57
3. Spacer
4. Nut
g257979
(Figure
g257903

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx 100022327g22327hd2232822328hd

Table of Contents