Table of Contents
Advertisement
Shipping condition
Shipping condition allows you to reset the TV to its original condition, i.e. no channels tuned in.
This is useful, for example, if you move to a different area when you will probably want the TV to tune itself to your
new local stations.
Note:
Owner ID information will not be affected by this function.
This can be done either through the Shipping condition menu or through the Auto setup menu.
The Shipping condition menu will reset all data, except Owner ID information, clearing all DVB and Analogue tuning
information and resetting all control levels back to factory settings.
You may need to adjust your VCR or programme position '0' VCR after operating the Shipping condition menu.
Press the MENU button.
Move to Setup menu.
Access Setup menu.
Move to Shipping condition.
Access Shipping condition.
Press the OK button to start.
Press again, to confi rm, each time that you are asked, "Are you sure?".
Switch the TV off at the mains power switch.
The next time you switch the TV on, Auto setup will begin. DVB and
Analogue stations will be located, sorted and stored ready for use. See
page 9.
22
MENU
OK
1
2
3
4
5
6
7
8
9
C
0
OK
IDTV
Setup menu
Q-Link
AV2
Monitor
AV2 out
Teletext
FASTEXT
Off
Off timer
Off
Side panel
Off
Power save
Power on preference
TV
Tuning Menu
Owner ID
Shipping condition
Access
Shipping condition
All tuning data will be erased
Are you sure ?
Are you sure ?
Start
Exit
Return
Advertisement
Table of Contents
Troubleshooting
