Table of Contents
Advertisement
The following illustration shows how to close the blade server cover.
Complete the following steps to close the blade server cover:
1. Review the information in "Safety" beginning on page v and "Installation
2. If you removed the blade bezel assembly, replace it now. See "Installing the
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
4. Pivot the cover to the closed position as shown in the illustration, until it clicks
Installing the blade server in the BladeCenter unit
Blade-cover
release
guidelines" on page 15.
blade server bezel assembly" on page 32 for instructions.
of the blade server, as shown in the illustration. Before closing the cover, check
that all components are installed and seated correctly and that you have not left
loose tools or parts inside the blade server.
into place.
Blade-cover
Cover
release
pins
Chapter 3. Installing options
33
Advertisement
Table of Contents
