Table of Contents
Advertisement
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1.
Loosen the cable-support nut
Figure 21
1. 25 to 38 mm (1 to 1-1/2
inches)
2. Self-propel-drive bar
3. Cable jacket
2.
Hold the self-propel-drive bar 25 to 38 mm (1 to
1-1/2 inches) from the handle
3.
Pull down the cable jacket (toward the machine)
until there is no slack in the cable
4.
Tighten the nut on the cable support.
5.
Release the self-propel-drive bar and ensure
that the cable is loose.
Note:
The cable must be loose with the
self-propel drive bar in the released position;
otherwise, the machine may creep when you
disengage the bar.
(Figure
21).
g009692
4. Cable-support nut
5. Cable support
(Figure
21).
(Figure
21).
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Lithium-ion battery packs labeled with the
Call2Recycle seal can be recycled at any
participating retailer or battery recycling
facility in the Call2Recycle program (US
and Canada only). To locate a participating
retailer or facility closest to you, please call
1-800-822-8837 or visit www.call2recycle.org.
If you cannot locate a participating retailer or
facility nearby, or if your rechargeable battery
is not labeled with the Call2Recycle seal,
please contact your local municipality for more
information on how to responsibly recycle the
battery. If you are located outside of the US
and Canada, please contact your authorized
Toro distributor.
19
Advertisement
Table of Contents
