Page 1
DV 7120 Dryer User manual 2960310584_KM/280814.1900...
Page 2
Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference.
Important safety information This section includes safety information that will well as the items that are contaminated help protection from risks of personal injuries or spotted with such materials should not or materialistic damages. Failure to follow be dried in the product since they emit these instructions shall cause any warranty and flammable or explosive vapor.
Children’s safety water! There is the risk of electric shock! Always disconnect by unplugging from the • Electrical appliances are dangerous for mains before cleaning. the children. Keep children away from the • Never touch the plug with wet hands. machine when it is operating.
Installation Refer to the nearest Authorised Service Agent approximate weight of both machines may for installation of your product. reach 180 kg when they are full. Therefore, Preparation of location and electrical the floor must be capable of carrying the installation for the product is under load on it! customer’s responsibility.
Page 6
connected to the chimney of a stove or a Damaged power cable must only be fireplace. replaced by a qualified electrician. Do not operate your product at the same If the product is faulty, it must not be time with heaters such as a coal or gas operated unless it is repaired! There is the stove.
Technical Specifications Height (adjustable) 85.0 cm Width 59.5 cm Depth 54 cm Capacity (max.) 7 kg Weight (net) 31 kg Voltage Rated power input See type label Model code Type label is located behind the loading door. 7 EN...
Initial preparations for drying Things to be done for energy A B C saving: • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them.
alcohol, fuel oil, kerosene, stain remover, Place your laundry into the drum loosely so turpentine, paraffin and paraffin removers that they will not get tangled. must be washed in hot water with plenty of Large pieces (E.g.: bed sheets, quilt covers, detergent before being dried in the dryer.
Selecting a Programme and Operating Your Machine Control panel 1. Filter cleaning warning light 4. On/Off button Warning light turns on when the filter is full. Used to turn on and off the machine. 2. Program follow-up indicator 5. Programme selection knob Used to follow-up the progress of the Used to select a programme.
Preparing the machine laundry from creasing will be activated if you do not take the laundry out after the programme 1. Plug in your machine. is over. This programme rotates the laundry in 2. Place the laundry in the machine. 10-minute intervals to prevent creasing.
Auxiliary function button for about 3 seconds to “Cancel” the programme in order to select “Extra Cancel audio warning Dry” programme instead of “Iron Dry” Your dryer will give an audio warning when the programme. programme comes to an end. If you do not 2.
End of programme audio warning” buttons simultaneously for 3 seconds to activate the child-press lock. The “End/Anti-creasing”, “Filter cleaning” and To start a new programme after the programme “Water tank” warning lights on the programme is over or to interrupt the programme, the child- follow up indicator will turn on when the proof lock should be deactivated.
Maintenance and cleaning Sensor (models with a sensor) Cover filter There are humidity sensors in your dryer that detect Lint and fibres released from the laundry to the air whether the laundry is dry or not. during the drying cycle are collected in the “Cover Filter”.
Solution suggestions for problems Drying process takes too much time • Meshes of the filter may be clogged. Wash with water. Laundry come out wet at the end of drying. • Meshes of the filter may be clogged. Wash with water. •...