Table of Contents
Advertisement
Steps
1. Using the alignment posts, place the I/O board on the palm-rest and keyboard assembly.
2. Route the I/O-board cable through the routing guides on the fan.
3. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
4. Connect the I/O-board cable to the I/O board and close the latch to secure the cable connector.
5. Adhere the tape that secures the I/O-board cable connector to the I/O board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Heat sink
Removing the heat sink (integrated graphics)
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
About this task
The following image indicates the location of the heat sink (on systems with the integrated graphics option) and provides a
visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
27
Advertisement
Table of Contents
