Table of Contents
Advertisement
KV-[13M40/50/51], KV-[14MB40/40C/40A], KV-[20M40/S40/S41/V80], KV-[21SE40/40A/40C/80/80A/80C],
KV-[21MB40C/40M/40P], KV-[21ME40/40P], KV-[21SB40/40M/40P], KV-21XT4A
DISPLAY POSITION ADJUSTMENT (DISP)
1. Input a color-bar signal.
2. Set to Service adjustment Mode.
3. Select DISP with
and
4. Adjust with
and
for adjustment of characters to center .
5. Write the memory by pressing
6. Check if the text is displayed on the screen.
SERVICE
SUB BRIGHT ADJUSTMENT (SBRT)
1. Input a cross-hatch signal.
2. Set to Service adjustment Mode.
3. Set the PICTURE and BRIGHT to minimum.
4. Select SBRT with
and
5. Adjust with
and
to obtain a faintly visible cross-hatch.
6. Write into the memory by pressing
SUB HUE, SUB COLOR ADJUSTMENT (SHUE, SCOL)
1. Input a color-bar signal.
2. Set to Service adjustment Mode.
3. Select the item DCOL and set to "0" level.
4. Connect an oscilloscope to
CN702 Pin 5 (for 20"/21") (BLUE OUT) of C Board and
ground.
5. Select SHUE and SCOL with
for the V1 = V4 ± 0.1Vp-p (SCOL)
6. Adjust with
and
and V2 = V3 ± 0.1Vp-p (SHUE).
V1
V2 V3 V4
7. Reset the item DCOL to "1" level.
8. Write into the memory by pressing
V. SIZE ADJUSTMENT ( VSIZ)
1. Input a cross-hatch signal.
2. Set to Service adjustment mode.
3. Select VSIZ with
and
4. Adjust with
and
for the best vertical size.
V. SIZE (VSIZ)
/
.
then
DISP
15
.
then
5
CN752 Pin
(for 13"/14") or
and
.
then
.
V. CENTER ADJUSTMENT (VPOS)
1.Input a cross-hatch signal.
2.Set to Service adjustment Mode.
3.Select VPOS with
4.Adjust with
and
.
5.Write into the memory by pressing
V. CENTER (VPOS)
/
H. CENTER ADJUSTMENT (HPOS)
Note : Perform this adjustment after checking H. FREQUENCY.
1. Input a cross-hatch signal.
2. Set the Service adjustment Mode.
3. Select HPOS with
4. Adjust with
and
5. Write into the memory by pressing
.
H. CENTER (VPOS)
/
V. LINEARITY (VLIN) AND V CORRECTION
1. Input a cross-hatch signal.
2. V. Correction is automatically adjusted from the circuit and
should satisfy the conditions below:
...
SERVICE ADJUSTMENT MODE MEMORY
.
1. Change DCOL to "1".
2. After completing all adjustments, press "0" then
READ FROM MEMORY
SERVICE
— 28 —
and
.
for the best vertical center.
then
?
and
.
for the best horizontal center.
then
?
READ
Green
0
Red
.
Hide quick links:
Advertisement
Chapters
Table of Contents
