Table of Contents
Advertisement
Quick Links
Quick reference guide
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With "Delayed start"
selected it indicates the time remaining until program start (h.00) - below 1h (0:min).
If "Fx Ey" messages appears on the display, see page 9 - chapter "What to do if...".
PROGRAM SELECTION
DELAYED START
BUTTON
BUTTON
Push "P" button (repeatedly)
Push the button (repeatedly) to
until selected program number
delay the start of the program -
is shown on the display
delay indicator turns on.
(P1...Px) - see "Table of
Adjustable from 1 to 24 hours.
programs" next page.
With each press of the button,
the delay increases by one hour
and after "h 24" returns to
"h 00". When this option is
selected the delay indicator
turns on. Then press the
START button. The
dishwasher will start after the
set time.
Whirlpool is a registered trademark of Whirlpool USA
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
POWER CLEAN
TABLET SETTING
Thanks to the additional
This setting allows to optimize
power jets this option provides
the cycle performances
a more intensive and powerful
according the type of detergent
wash in the lower rack, in the
used. Push the Tablet button
specific area. This option is
for 3 seconds (until the
recommended for washing
indicator lights up) if you are
pots and casseroles (see page
using the combined detergents
7). Press this button to activate
in tablet (rinse aid, salt and
Power Clean (the indicator
deteregent in 1 dose). If you
lights up).
are using powder detergent or
liquid detergent, the Tablet
indicator on the control panel
has to be off.
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
START/RESUME
BUTTON
Push this button to start the
selected program: the indicator
lights up and goes off at the end
of the program.
When the door is opened
during a washing cycle, the
cycle is temporarily paused:
the Start indicator blinks.
To resume the cycle close the
door and push Start button
again.
Chart
5019 300 02292
CANCEL/OFF BUTTON
Push this button to switch off
the control panel.
If pressed when a program is
running it cancels the program
ongoing draining water for 1
minute (0:01 is shown into the
display).
If pressed when the dishwasher
is switched off, it drains any
possible liquids from
dishwasher (1 minute process).
EN -1-
Advertisement
Table of Contents
Related Manuals for Whirlpool ADPU7653A
Summary of Contents for Whirlpool ADPU7653A
- Page 1 Then press the door and push Start button indicator on the control panel START button. The again. has to be off. dishwasher will start after the set time. Whirlpool is a registered trademark of Whirlpool USA EN -1-...
- Page 2 2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
-
Page 3: First Time Use
First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set only - Press and hold together PROGRAM Selection and CANCEL/Off buttons for minimum 3 seconds. before the first wash or if water - The current water hardness setting will be visible on the display. -
Page 4: Daily Use
Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Visual The rinse aid dosage can be adjusted to the detergent indicator used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). -
Page 5: How To Load The Racks
How to load the racks Cutlery rack Load cutlery with the handle into the pins. Knives or cutlery with bulky handle can be loaded with the head into the pins. How to remove cutlery rack (if available) - It could be useful to remove cutlery rack to load stem glasses in upper rack. - Page 6 How to load the racks Upper rack In the upper rack you can load glasses, cups, bowls and, in the right side of the rack, you can load the dessert dishes. Foldable flaps (A) when open help to load stemmed glasses, long tools or coffee cups. Plate holders (B) can be folded down to load bowls.
- Page 7 How to load the racks Lower rack In the lower rack plates and pots can be loaded. Vertical plate holders (E) can be When the “Half load/Multizone” option is selected the cutlery basket - F folded down to create more space to load pots. (provided in some models) can be placed in the lower rack.
-
Page 8: Maintenance And Care
Select program Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. - Page 9 What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 10 What to do if... Crockery and cutlery... Possible causes... Solutions..are not perfectly clean/have food - T oo little space between dishes (incorrect - Arrange crockery so that items do not touch each other. Concave items (e.g. residues arrangement of the concave items in the rack). bowls, cups) must be arranged facing downwards in the rack.
- Page 11 What to do if... Crockery and cutlery... Possible causes... Solutions..have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening.
- Page 12 Precautions and general recommendations 1. Packing - Before cleaning or carrying out maintenance, disconnect the mains plug and turn The packaging materials are 100% recyclable and marked with the recycling symbol off the water tap; also in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician.