Using the microphone
You can use the built-in or an external microphone that connects to the
microphone jack to record monaural sounds into your applications. It can
also be used to issue voice commands to applications that support such
functions. Since your computer has a microphone and speaker, "feedback"
may be heard under certain conditions. Feedback occurs when sound from
the speaker is picked up in the microphone and amplified back to the
speaker, which amplifies it again to the microphone.
This feedback occurs repeatedly and causes a very loud, high-pitched
noise. It is a common phenomenon that occurs in any sound system when
the microphone input is output to the speaker (throughput) and the speaker
volume is too loud or too close to the microphone. You can control
throughput by adjusting the volume of your speaker or through the Mute
function in the Master Volume panel. Refer to your Windows documentation
for details on using the Master Volume panel.
Wireless communications
The computer's wireless communication function supports both Wireless
LAN and Bluetooth devices.
Wireless LAN
The Wireless LAN is compatible with other LAN systems based on Direct
Sequence Spread Spectrum/Orthogonal Frequency Division Multiplexing
radio technology that complies with the IEEE802.11 Wireless LAN
standard.
■
Frequency Channel Selection of 2.4GHz for 802.11bg or n draft 2.0
■
Roaming over multiple channels
■
Card power management
■
Wired Equivalent Privacy (WEP) data encryption based on an 128-bit
encryption algorithm
■
Wi-Fi Protected Access™ (WPA™) support
■
Advanced Encryption Standard (AES) data encryption
■
The transmission speed over the wireless LAN, and the distance over
which the wireless LAN can reach, may vary depending on
surrounding electromagnetic environment, obstacles, access point
design and configuration, client design and software/hardware
configurations. The transmission rate described is the theoretical
maximum speed as specified under the appropriate standard - the
actual transmission speed will be lower than the theoretical maximum
speed.
■
To enable or disable wireless communication, use the Hot Key
FN + F8. For more information see the
User's Manual
Operating Basics
Hot keys
section in Chapter 5.
4-8