Table of Contents
Advertisement
Available languages
Available languages
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by
one or more adjustable feet at the base of the cab-
inet.
If the cabinet is placed in a corner and the side with
the hinges facing the wall, the distance between
the wall and the cabinet must be at least 10 mm
to allow the door to open enough so that the
shelves can be removed.
Warning! It must be possible to disconnect
the appliance from the mains power supply;
the plug must therefore be easily accessible after
installation.
Door reversibility
Important! To carry out the following operations,
we suggest that this be made with another person
that will keep a firm hold on the doors of the
appliance during the operations.
To change the opening direction of the door, do
these steps:
1. Remove the plug from the power socket.
2. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom hinge.
Remove the hinge. Put over the pin in the di-
rection of the arrow.
5. Unscrew and install the screw on the opposite
side.
6. Install the hinge on the opposite side.
7. Screw both adjustable feet.
8. Unscrew both screws on the rear side.
9. Push back the top and lift it from the fixing el-
ements.
10. Unscrew the screws of the door top hinge.
11. Remove the hinge. Put over the pin in the di-
rection of the arrow. Install the hinge on the
opposite side.
12. Tighten the hinge.
13. Put the top in position.
electrolux 27
Advertisement
Table of Contents
