Frigidaire FFAD6022W1 - Frigidaire High Humidity 60 Pint Capacity Dehumidifier Manual

INTRODUCTION

This manual is your resource for the use and care of your product. Please read it before using your appliance. Keep it handy for quick reference. If something doesn't seem right, the troubleshooting section will help you with common issues.

FAQs, helpful tips and videos, cleaning products, and kitchen and home accessories are available at www.frigidaire.com.

We are here for you! Visit our website, chat with an agent, or call us if you need help. We may be able to help you avoid a service visit. If you do need service, we can get that started for you.

Let's make it official! Be sure to register your product.

Keep your product info so it's easy to find.

LOCATION

Selecting a Location

1. Dehumidifier must be operated in an enclosed area to be most effective. Close all doors, windows, and other outside openings to the room. The effectiveness of the dehumidifier depends on the rate at which new moisture-laden air enters the room.
2. Place dehumidifier in a location that does not restrict the airflow of the air intake and air outlet.
3. A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed storage area, such as a closet, unless there is adequate circulation of air in and out of the area. lt may be necessary to install a second dehumidifier in the enclosed area for satisfactory drying.
4. The dehumidifier must be installed on a level floor that will support it with a full bucket of water.
5. There should be a minimum of 12 inches clearance around the dehumidifier. The unit will produce heat while in operationand should not be operated in an enclosed small space like a closet.
   

HOW IT WORKS

When the unit is started, the fan begins to pull moisture-laden air across the dehumidifying coils. The coils condense or draw moisture from the air, and air flows through the air outlet louvers into the room as dry, warm air. Moisture removed from air is collected in a bucket on the front of the dehumidifier.

The unit is designed to operate between 41°F (5°C), and 89°F (32°C). The unit will not work properly if the temperature is out of this temperature range, or the performance of the unit will fall greatly.

The "Compressor" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. Make sure the tank is fitted correctly otherwise unit will not turn on.

Wiring Diagram

DEHUMIDIFIER FEATURES

ELECTRONIC CONTROL

Before you begin, thoroughly familiarize yourself with the control panel and all its functions (as shown below).

1. Auto Mode Button
2. Continue Drain Button
3. Sets Timer
4. Defrost Indicator
5. Bucket Full Indicator
6. Displays Humidity
7. Turns Unit On Or Off
8. Adjusts Humidity
9. Turbo Fan Button
10. Check Filter Reset Button

OPERATING INSTRUCTIONS

Allow the unit to reach room temperature before operating.

To begin operating the dehumidifier, follow these steps:

NOTE

Unit must be upright for one hour prior to operating.

1. Plug the power cord into a properly grounded 115 volt AC outlet.

   NOTE

   If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.

2. To turn the unit on, press the button. The unit will run in Auto mode. In this mode, the unit will automatically set a comfortable humidity and fan speed according to the indoor environment. When room temperature < 65˚F, the humidity will be set as 55% When room temperature ≥ 65˚F and ≤ 77˚F, the humidity will be set as 50%; When the room temperature T > 77˚F, the humidity will be set as 45%. In Auto mode press or button will cancel this feature.
   
3. It is recommended to press the Cont. Drain button to use the CONTINUOUS setting for the first three or four days until the sweating and dampness odors have stopped. In this setting the unit will run in the maximum power and the display will show actual room humidity.
   
4. Press the Turbo Fan button to activate the Turbo Fan feature. In this feature the unit will run in high fan speed to maximize the dehumidification speed.
   
5. After a few days when the Relative Humidity has declined, press the Cont. Drain button to deactivate the Cont. Drain feature then press the HUMIDITY or buttons to choose a value between 35% to 85%, so the room is kept at a comfortable humidity. Pressing the or buttons will change the humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual room humidity.
   
6. When the unit is on, first press the Timer button, the Timer Off indicator light illuminates. It indicates the Auto Stop program is initiated. Press it again the Time On indicator light illuminates. It indicates the Auto Start is initiated.
   When the unit is off, first press the Timer button, the TIMER ON indicator light illuminates. It indicates the Auto Start program is initiated. Press it again the Time Off indicator light illuminates. It indicates the Auto Stop is initiated.
   Press or hold the UP or DOWN pad to change the Auto time by 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start.
   The selected time will register in 5 seconds and the system will automatically revert back to display the previous humidity setting.
   When the Auto start & Auto stop times are set, within the same program sequence, TIMER ON OFF indicator lights illuminate identifying both ON and OFF times are now programmed.
   Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the Auto Start/Stop function.
   When LED display window displays the code of P2, the Auto Start/Stop function will also be cancelled.
   

   NOTE:

   Before entering TIMER setting, make sure power is being supplied to the unit. Before entering TIMER setting, make sure pressing HUMIDITY or button sets one desired room humidity first.

7. The CLEAN FILTER light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the FILTER button to extinguish the light.
   
8. When frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue to run until the frost disappears.
   
9. To shut the unit down, press the ON/OFF button.
   
   Note: After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.

Fault Codes

1. If the display reads "AS" or "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center.
   
2. If the display reads "P2", Bucket is full or removed or not in right position. Replace the bucket in the right position.
   

Removing Collected Water

1. Emptying the Bucket:
   1. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.
      
   2. Do not move the unit at this time otherwise water may spill on the floor.
   3. Press sides of bucket gently to unclip the bucket from the unit.
   4. Remove the bucket as shown in the photographs below and empty the bucket.
      

      Discard water from bucket. Water is not potable and cannot be used for drinking.

   5. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
   6. You should hear a click when the bucket is in the correct position.
2. Continuous Drainage:
   1. For continuous drainage operation, you will need a garden hose and a drain nearby to discharge the water into.
   2. Unscrew the drain cap on the back side of the unit. (fig.1)
      
   3. Insert the female threaded end of the hose onto the drain connector of the unit. (fig.2)
      
   4. Screw the garden hose onto the threaded portion of the drain connector. (fig.3)
      
   5. Make sure the hose is secure so there are no leaks.
   6. Direct the hose toward the drain, making sure that there are no kinks that will stop the water flowing.
   7. Place the end of the hose into the drain. (fig.4)
      
   8. Select the desired humidity setting and fan speed on the unit for continuous draining to start.

NOTE

Check the seal between the hose and the drain connector. If there is a small leak then replace the hose gasket and re-tighten the hose. It is recommended that a Dehumidifier Drain Hose - 1/2" (12.7 mm) or larger be used. Make sure there are no kinks or elevations in the hose. When a hose is not attached to the drain connector, please ensure drain cap is screwed securely to the connector to prevent leakages.

CARE AND CLEANING

1. Filter
   Clean the filter every two weeks based on normal operating conditions.
   To remove the filter:
   1. Remove the back grille every two weeks based on normal operating conditions.
   2. To remove the back grille, pull back grille outwards (see figure below).
      
   3. Wash the back grille with clean water then dry.
   4. Re-install the back grille.
2. Cabinet
   1. Dust cabinet with an oil-free cloth, or using a damp cloth.
   2. Vacuum grill using brush attachment.
3. Water Bucket
   1. Clean bucket with warm water and detergent.

STORAGE

When unit is not in use, unplug and use the cord wrap shown for your model type.

NORMAL SOUNDS

1. Dripping Sound
   The sound of dripping water may be heard during the dehumidification cycle.
2. Sound of Rushing Air
   At the top of the unit, you may hear the sound of rushing air being moved by the fan.
3. Gurgle/Hiss
   "Gurgling or hissing" noise may be heard due to refrigerant passing through evaporator during normal operation.
4. High pitched Chatter
   Today's high efficiency compressors may have a high pitched chatter during the dehumidification cycle.

BEFORE YOU CALL

Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

If These Solutions Fail, Call 1-800-944-9044(US)/1-800-265-8352(Canada) For Frigidaire Service.

welcome home

Our home is your home. Visit us if you need help with any of these things:

owner support

accessories

service

registration
(See your registration card for more information.)

Frigidaire.com
1-800-944-9044

Frigidaire.ca
1-800-265-8352

IMPORTANT SAFETY INSTRUCTIONS

For Your Safety Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read product labels for flammability and other warnings. Discard water from bucket. Water is not potable and cannot be used for drinking.

Electrical Information For your safety and protection, this dehumidifier is equipped with a three-prong grounding plug on the power cord. Do not, under any circumstances, cut or remove the round ground prong from the plug. Your dehumidifier must be plugged directly into a properly grounded and polarized three-prong receptacle. lf the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet according to the National Electrical Code and applicable local codes and ordinances. Do not use an extension cord or an adapter plug. Never unplug the dehumidifier by pulling on the power cord. Always grip the plug firmly and pull straight out from the receptacle. Do not pinch, bend, or knot the power cord.

Child Safety Precautions Destroy the carton, plastic bags, and any packing materials immediately after the dehumidifier is unpacked. Children should never use these items for play. Do not leave children unattended in an area where the appliance is operating. Do not allow them to sit or stand on the appliance. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

SAFETY PRECAUTIONS

Avoid Serious Injury or Death This dehumidifier contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs. Do not insert or place fingers or objects into the air discharge area or back grille of the unit. Do not start or stop the dehumidifier by unplugging the power cord or turning off the power at the electrical box. Do not cut or damage the power cord. Do not pull on the power cord. If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer. In the event of a malfunction (sparks, burning smell, etc.), immediately stop the operation, disconnect the power cord, and call an authorized Electrolux servicer. Do not operate the dehumidifier with wet hands. Do not drink any water from the dehumidifier. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. The appliance shall be installed in accordance with national wiring regulations. Avoid Injury or damage to the unit or other property Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups. Do not climb on or place objects on the unit. Do not hang objects off the unit. Do not place containers with liquids on the unit. Turn off the dehumidifier at the power source when it will not be used for an extended period of time. Operate the unit with air filter in place. Do not block or cover the intake grille, discharge area and outlet ports. Ensure that any electrical/electronic equipment is one yard away from the unit. Do not use or store flammable gases near the unit.

Avoid fire hazard or electric shock. Do not use an extension cord or an adaptor plug. Do not remove any prong from the power cord. Grounding type wall receptacle