Cleaning; Cleaning Under The Mower; Disposing Of Waste; Storage - Toro Z Master Professional 6000 Series Operator's Manual
With 60in or 72in turbo force side discharge mower
Hide thumbs
Also See for Z Master Professional 6000 Series:
- Operator's manual (80 pages) ,
- Setup instructions (16 pages) ,
- Operator's manual (68 pages)
Table of Contents
Advertisement
Cleaning
Cleaning under the Mower
Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the mower to the transport position.
Disposing of Waste
Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
Storage
Cleaning and Storing the
Machine
1. Disengage the power-take off (blade-control switch
(PTO), set the parking brake, and turn the ignition key
to the Off position, and remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine (especially the
engine and hydraulic system). Clean dirt and chaff
from the outside of the engine-cylinder-head fins and
the blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to Adjusting the Parking Brake
(page 50).
4. Service the air cleaner; refer to Servicing the Air
Cleaner (page 35).
5. Grease the machine; refer to Lubrication (page 33).
6. Change the crankcase oil; refer to Servicing the Engine
Oil (page 36).
7. Check the tire pressure; refer to Checking the Tire
Pressure (page 45).
8. Change the hydraulic filters; refer to Replacing the
Hydraulic Filters and Hydraulic Oil (page 56).
9. Charge the battery; refer to Servicing the Battery (page
42).
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the blade-control switch
(PTO) engaged and the engine at high idle for 2 to
5 minutes after washing.
11. Check the condition of the blades; refer to Servicing
the Cutting Blades (page 60).
12. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
64
Advertisement
Table of Contents
