Table of Contents
Advertisement
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start a programme suitable for
the type of load and the degree of soil.
9.1 Using the detergent
A
B
30
20
CAUTION!
Only use detergent specifically designed
for dishwashers.
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets, in
the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the release
button locks into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
Do not fill the compartment (A) with more
than 30 ml of gel detergent.
C
9.2 Setting and starting a
programme
The Auto off function
This function decreases energy consumption
by deactivating automatically the appliance
when it is not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not
started.
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode and the
door is closed.
2. Press Program again and again until the
indicator of the desired programme is on.
The display shows the programme duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running phase is
on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with delay start
1. Set a programme.
2. Press Delay repeatedly until the display
shows the desired delay time (from 1 to
24 hours).
3. Press Start to begin the countdown.
• The indicator
• The remaining time counts down in
hours. The final hour is displayed in
minutes.
When the countdown is completed, the
programme starts and the indicator of the
running phase is on. The indicator
Opening the door while the appliance
operates
Opening the door while a programme is
running stops the appliance. It may affect the
energy consumption and the programme
is on.
is off.
ENGLISH
15
Advertisement
Table of Contents
