Table of Contents
Advertisement
Available languages
Available languages
10.3 Cleaning the condenser
condenser flashes on the
If the symbol
display, inspect the condenser and its
compartment. If it is dirty, clean it. Do the
check not less than once a 6 months.
WARNING!
Do not touch the metal surface with bare
hands. Risk of injury. Wear protective
gloves. Clean carefully to avoid
damaging the metal surface.
To inspect:
1. Open the door. Pull the filter up.
2. Open the condenser cover.
3. Turn the lever to unlock the condenser
lid.
20
ENGLISH
4. Lower the condenser lid.
5. If necessary, remove the fluff from the
condenser and its compartment. You can
use a vacuum cleaner with the brush
attachment.
6. Close the condenser lid.
7. Turn the lever until it clicks into position.
8. Put the filter back.
10.4 Cleaning the humidity sensor
CAUTION!
Risk of humidity sensor damage. Do not
use abrasive materials or steel wool to
clean the sensor.
To assure best drying results the appliance is
equipped with metal humidity sensor. It is
placed on the inner side of the door area.
Over usage time the surface of the sensor
may get dirty which deteriorates the drying
performance.
We recommend to clean the sensor at least 3
or 4 times or if you observe the drop of drying
performance.
To clean you can use harder side of dish-
washing sponge and bit of vinegar or dish
soap.
To clean the sensor:
1. Open the loading door.
Advertisement
Chapters
Table of Contents
