Table of Contents
Advertisement
5.6
Motion Sensor
This setting is available only for the motion sensor kit.
<Function>
* The motion sensor detects a human activity by the change of the infrared light.
This function saves the air conditioning capacity (adjusting the set temperature and the air flow volume)
automatically depending on a situation.
* The operation after the motion sensor detects as absence can be selected from "Running", "Stand-by"
or "Stop" on the wired controller with the capacity saving.
l Do not use the motion sensor function when a baby or a handicapped person stays by oneself.
The motion sensor may detect as absence and the operation may be stopped in the case of staying for
long time with a bit motion.
l The motion sensor detects the human activity. However, if someone is in a room with a bit motion, the
motion sensor may detect as absence.
l The motion sensor may detect as human activity if the indoor unit with the motion sensor kit is installed
near a moving object (ex. swing operation of a heating appliance) which is difference in temperature
against atmosphere.
l In the case that the indoor units are operated by 2 wired controllers, the motion sensor setting is available
only from the main wired controller.
l The indoor unit operation can be stopped by the motion sensor control.
NOTE:
The indoor unit without the motion sensor kit and the indoor unit with the motion sensor kit can be mixed to
install.
In this case, when the operation is stopped by the motion sensor control, the indoor unit without the motion
sensor kit will also stop the operation.
l While the air conditioning capacity is saved or the operation is stopped by the motion sensor control, "Motion
sensor is activated" is displayed on LCD.
l If the function "Prohibiting operation by wired controller" is used from the centralized controller, select the
command "Running" or "Stand-by" in "If absent" at the motion sensor control setting.
If "Stop" is selected, the motion sensor control can not be performed correctly as follows.
* In the case that "Stop" is selected in the motion sensor control setting and "Prohibiting operation by
wired controller" (for all items) is set by the centralized controller, the operation will not be stopped even
if the motion sensor control function changes to the stoppage condition.
* In the case that "Stop" is selected in the motion sensor control setting and "Prohibiting operation by
wired controller" (for part of items) is set by the centralized controller, the indoor unit operation can not
be restarted from the centralized controller although the operation can be stopped under the stoppage
condition by the motion sensor control function.
16
NOTICE
P5417020
Advertisement
Table of Contents
