Table of Contents
Advertisement
Connection and Signal Strength status
The intensity of the data communication and radio wave are shown in the levels of
18 asterisks. Install Network Camera in the highest level after confirming the data
communication and signal strength status. At the lower levels, Network Camera
may easily lose wireless communication.
1.
Set [Infrastructure] (Default) or [AdHoc].
[Infrastructure] enables Network Camera to communicate with the wireless
router that control transmission paths on the network.
•
[Infrastructure] automatically adjusts the channel.
[AdHoc] enables Network Camera to connect with the other wireless terminal
in peer-to-peer communication. [AdHoc] requires IEEE 802.11b wireless
devices such as wireless LAN card and wireless USB adaptor.
•
Set the channel used in the wireless network. Channel can be selected 1—
11. (Default is Channel 6.)
Channel
Many wireless devices on the same channel make the communicating
speed slower. Set 5 channels apart to prevent the bandwidth from
overlapping. If another wireless network use Channel 6, you may use
Channel 1 or 11.
2.
Set SSID (ESSID) of the wireless router or the wireless LAN card.
SSID is the wireless network name. SSID determines the communicable
network group on the wireless network. Set the same SSID to the wireless
devices on the wireless network. If SSID is different, Network Camera cannot
be viewed on the wireless network.
•
SSID is case sensitive.
•
Max. 32 characters
•
Refer to unavailable characters set 1 on page 104.
3.
The wireless communication speed can be set. [Auto] setting optimizes the
performance.
•
Parameters are 1, 2, 5.5, 11 Mbps and Auto.
[For assistance, please call: 1-800-272-7033]
Operating Instructions
33
- Quick Links:
- Installation Procedure
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
