Table of Contents
Advertisement
Frequently Asked Questions About RACADM Error Messages
After performing an iDRAC6 reset (using the racadm racreset command),
I issue a command and the following message is displayed:
ERROR: Unable to connect to RAC at specified
IP address
What does this message mean?
You must wait until the iDRAC6 completes the reset before issuing
another command.
When I use the racadm commands and subcommands, I get errors that
I don't understand.
You may encounter one or more of the following errors when using the
commands and subcommands:
RACADM
•
Local
RACADM
errors, and incorrect names.
•
Remote
RACADM
incorrect username, or incorrect password.
When I ping the iDRAC6 IP address from my system and then switch my
iDRAC6 between Dedicated and Shared modes during the ping response,
I do not receive a response.
Clear the ARP table on your system.
Remote RACADM fails to connect to iDRAC from SUSE Linux Enterprise
Server (SLES) 11 SP1
Ensure that you have installed the official openssl and libopenssl versions.
Run the following command to install the RPM packages:
rpm -ivh --force
where, <filename> is the openssl or libopenssl rpm package file.
For example:
rpm -ivh --force openssl-0.9.8h-30.22.21.1.x86_64.rpm
rpm -ivh --force libopenssl0_9_8-0.9.8h-
30.22.21.1.x86_64.rpm
error messages — Problems such as syntax, typographical
error messages — Problems such as incorrect IP Address,
< filename >
Advanced iDRAC6 Configuration
117
- Quick Links:
- Diagnostic Commands
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
