Table of Contents
Advertisement
Updating the iDRAC6 Firmware Using the Web-Based Interface
For detailed information, see "Updating the iDRAC6 Firmware/System
Services Recovery Image" on page 77.
Updating the iDRAC6 Firmware Using RACADM
You can update the iDRAC6 firmware using the CLI-based RACADM tool.
If you have installed Server Administrator on the managed system, use local
RACADM to update the firmware.
1 Download the iDRAC6 firmware image from the Dell Support website at
support.dell.com to the managed system.
For example:
C:\downloads\firmimg.d6
2 Run the following RACADM command:
racadm fwupdate -pud c:\downloads\
You can also update the firmware using remote RACADM and
a TFTP server.
For example:
racadm -r <iDRAC6 IP address> -u <username> -p
<password> fwupdate -g -u -a <path>
where path is the location on the TFTP server where the firmimg.d6 is stored
including the TFTP server IP address.
Updating the iDRAC6 Firmware Using Dell Update Packages for
Supported Windows and Linux Operating Systems
Download and run the Dell Update Packages for supported Windows and
Linux operating systems from Dell Support website at support.dell.com.
For more information, see the Dell Update Package User's Guide available on
the Dell Support website at support.dell.com\manuals.
NOTE:
When updating the iDRAC6 firmware using the Dell Update Package utility
in Linux, you may see these messages displayed on the console:
usb 5-2: device descriptor read/64, error -71
40
Basic Installation of the iDRAC6
- Quick Links:
- Diagnostic Commands
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
