13. To complete the installation, go to "Completing the CRU replacement" on
Removing and replacing the hard disk drive
This section provides instructions on how to remove and replace the hard disk
drive.
1. Remove the cover. See "Removing the cover" on page 1.
2. Rotate the drive bay assembly upward to gain access to the system board.
3. Disconnect the signal and power cables from the rear of the hard disk drive.
4. Lift the hard disk drive and bracket up to remove it from the drive bay.
12
Hardware Removal and Replacement Guide
page 16.
Attention
Do not open your computer or attempt any repair before reading the
"Important safety information" in the Quick Reference that was included with
your computer. If you no longer have this copy of the Quick Reference, you
can obtain one online from the IBM Web site at
http://www.ibm.com/pc/support.
X
*
X
X
X
X
X
X
X
*
X
*
X
X
X
X
X
X
X
X
*
X
*
X
X
X
X
X
X
X
X
*
X
*
X
X
X
X
X
X
X
X
*
X