Dipswitch Setting For S5 - HP rp4410 Service Manual
User service guide, fifth edition - hp 9000 rp4410/4440
Hide thumbs
Also See for rp4410:
- Installation manual (103 pages) ,
- Manual (51 pages) ,
- Programmer's manual (109 pages)
Table of Contents
Advertisement
2.
Set the lower of the two blocks when the processor carrier is oriented with the extractor
handles toward you.
•
Set the dipswitch to the right (ON) position for PA-RISC. Do not disturb switch banks
1 through 4 beneath the sheet metal.
Figure 6-13 Dipswitch Setting for S5
3.
Align the processor extender board with the front and rear card guides.
4.
Slide the processor extender board down until it begins to seat in the socket located on the
midplane riser board.
5.
To fully seat the processor extender board into the socket on the midplane riser board, push
the extraction levers inward to the locked position.
6.
Replace the front cover. See
7.
Replace the front bezel. See
8.
Verify processor operation by using the system utilities.
•
To verify operation, use the iLO MP commands and the BCH commands.
•
To exercise the processor, use the MAKODIAG provided by the offline diagnostic
environment.
164
Removing and Replacing Components
"Replacing the Front Cover" (page
"Replacing the Front Bezel" (page
153).
152).
Advertisement
Table of Contents
Troubleshooting
